OWNER'S MANUAL ENFORCER 511 840 (315 Miz) / SLI 840-4 (433,92 MHz) Remote Controlled Key less Entry System with Alarm Sur SECO-LARM® INC.
ENFORCER® SLI 840/840-4 Owner's Manual CONGRATULATIONS From the moment yau purchased this ENFORCER Vehicle Security System, you became port of the SECULARISM family. You stared taking advantage of aver 30 years of addressed engineering. You joined team of engineers, technicians, designers, and people Fle yourself who know how important appreciating your cor is. You discovered the SEC O-LARM difference. This difference is important because the ENFORCER is mots than just on color.
ENFORCER® SLI 840/840-4 Owner's Manual ARMING There are two different ways to am your alarm, Tell your dealer which is best for you: LI Active Arming Turn your ignition OFF Close all the doors. Then pass the Lock button, the siren chirps and parking fights flesh once, tha alarm is fully armed.
ENFORCER® SLI 840/840-4 Owner's Manual a TOTAL PROTECTION ENFORLER® S51) 840/840-4 Owner's Manual EMERGENCY DISARM While your alarm is armed, your car is protected in tha following ways: ® Potential thieves or vandals should be deterred by the flagging LED.
ENFOREER?® SLI 840/840-4 Owner's Manual CE VALET Sometimes you may nat wish your alarm in arm when you leave your vehicle, (For instance, if you leave your car with a valet attendant, you may not want fo teach him haw the alarm operates.
ENFORCER® 5L1 840/840-4 Owner's Manual A —— Appendix 1 — UNDERSTANDING THE SIREN CHIRPS AND LIGHT FLASHES A. 1 chirp/flash: ® When the Lock button is pressed, the alarm is armed. ® When a door is closed, the slam will arm in 30 see. {passive arming}. ® 30 sec. after ignition switch is rued QFF and all doors are dived [or alloyed dome lights tum OFF}, the alarm is armed (passive wring). ® Successfully entered the vole mode, B. 2 chirps/Mashes: © When the Unlock button is pressed, the alarm is disarmed.
ENFORCER® SLi 840/840-4 Owner's Manual Don't forget the ACCESSORIES! 3 Ie: 7° or 5-7397544 Spare transmitter — (pi one for everyone who drives your car {2 included with color} $5-0528A or Duse-stage shack sensor « detects physical attacks on the vehicle, warns potential vandals, $5-051ME Sued-stage glass-beck sensor — Detects the high-frequency sound of glass braking SLI® 2594 Dual-stage microwave sensor — Detects movement inside car, protects open-fop vehicles NOTE — The accessories on this page are option
ENFORCER SLI 840 (315 MHz) SLI 840-4 (433.92 MHz) RF REMOTE CONTROLLED KEY LESS ENTRY SYSTEM WITH ALARM INSTALLATION BIANNUAL. Sur SECO-LARM® U.S.A, INC.
ENFORCER® SL] 840/840-4 Installation Manual I TABLE OF CONTENTS ENFORCER® SLI 840/840-4 Installation Manual GENERAL CONSIDERATIONS IMPORTANT: THIS ALARM IS INTENDED FOR INSTALLATION BY QUALIFIED PROFESSIONALS ONLY. READ BOTH THIS MANUAL AND THE OWNERS MANUAL COMPLETELY BEFORE BEGINNING THE INSTALLATION 1 Mike sure oll electrical connections are securely solders. . Di not run wires foo fitly. Allow some sack in case the wires ore accidentally polled by someone servicing the vehicle in the future.
ENFORCER® S11 840/840-4 Installation Manual Nepalese" RED/BLACK button a ; A Tide EY Ohio ToT ie och DBA) BROWN RIVE Contortion out C00 oan] *-RED Toi TT ok, FT anion 0A my PRAY Le +) Diplomata cutout 200mA max) GRAY/BLACK: To optional devices #rue. velar, car starker, #4.) 13 Fed ch. output (00M men] € BLACK/WHITE lock rl or rie Farsi Fossa Gore sia” BROWN/WHITE or Grok pod oes.
ENFORCER® Si] 840/840-4 Installation Manual WIRE CONNECTIONS 1. Connector {B-pin costarred} RED WIRE {5A fuse, fs +12VDC} 2. Connector (B-pin connector] ORANGE WIRE {io flash parking lights} Fig. 1 A. Determine if the parking lights are positively or negatively switched — Using a VOM meter, fest the wires coming farm the parking light switch.
ENFORCER® SL 840/840-4 Installation Manual Ee ee 4. Connector (3-pin connector) BLACK WIRE {ta chassis ground] Fig. 3 Choose o good chassis ground location, This is the mast important point of o successful installation. A poor ground connection will cause the siren fo continuously emit o low siren sound whenever the: alarm is armed. Use ane of the car's factory bolts fo consent to chassis ground.
ENFORCER® SUI 840/340-4 Installation Manual J 9. Contact (6-pin connector) BROWN/ WHITE WIRE {programmable passenger door sundeck or factory honking horn output) Fig. Ta and 7h Programmable Supplies either a momentary 200mA transistor ground cutout when the Unlock transmitter bunion is pressed a second dime within 15 seconds of disarming the alarm (passenger door unlock output], or a pulsing 200mA output fo drive a factory cor horn relay (hom honk). A. Passenger door unlock output [see fig.
ENFORCER® $1) 840/840-4 Installation Manual 15. Connector (3-pin connector) GRAY WIRE {ground output to lack, +12VDC output fo unlock} RED WIRE (+12VDC output) BROWN WIRE {ground output to unlock, +12VDC output fo lock) Figs. 13th 19 Chase 3 wires allow the alarm to control the power road flintlock systems of most vehicles without external relays, However, ore or twa relays moy be required in some ses. The alarm has a bull-in dimer which is programmable for 0.7 or 3.5 seconds. Most vehicles require 0 0.7.
ENFORCER® SLE 840/840-4 Installation Manual i: Single wire, negative shunt switching — This stern uses o single wire ta activate tha door locks. Applying ground on the LOCK/UNLOCK WIRE causes Fhe doors fo unlock, and removing the ground {oof applying +12VDC) causes the cads to lock, Found on some Mordants and Nissan. See fig. 18. G. Aftermarket door lock actuators — If the vehicle does not have power door locks, install aftermarket actuators interlarding fe she supplier's instructions.
ENFORCER® SLI 840/840-4 Installation Manual CODE LEARNING The alarm con learn a max. of 4 remotes. RF Code Wash™ deletes oll previous remotes when any new remote is lamed. This prevents unauthorized use of ghost ar stolen transmitters, and, sebaceous the user's transmitter no longer works, alerts the user if someone hes secretly code lacerated o new transmitter. However, it lase means Thai, when code learning is being dor, ALL THE USER'S TRANSMITTERS MUST RE CODE LEARNED AT THE SAME TIME. A.
{7} To program other features, press and release the Yep La bunion the number of dimes to reach the nex feature. For instance, if you just programmed fracture no. 2, and now wart fo program feature no. 4, press and senseless ths Veils button 2 more dimes. Then press and hold the Veep button to tun the feature ON or OFF as per spat (6).