User Manual

ManualsBrandsSuperior Electronics ManualsElectronicsTransmitter

ENFORCER 100LB/100CB Owner's Manual ENFORCER 100LB/100CB Owner's Manual

SECO-LARM U.S.A., Inc.

SECO-LARM

U.S.A., INC.

16842 Millikan Avenue

Irvine, California 92606

FILE: MOE100CFB.PMD/JAN2005

ORDER PART#760-930-1/170728

OWNER'S MANUAL

100LB • 100LB - 4

100CB • 100CB - 4

(315 MHz) (433.92 MHz)

Remote Controlled

Vehicle Security System

ENFORCER

Page 12

A. Arming indicator — Flashes quickly

during the 30-second rearm to show

passive arming countdown.

B. Door open indicator — OFF when a

hardwired door is opened during the

30-second rearm or passive arming

countdown.

C. Armed indicator — Flashes when the

alarm is armed.

D. Disarmed indicator — OFF when the

alarm is disarmed.

E. Tamper and triggered zone ID —

Flashes one or more times after the

alarm is disarmed to indicate which

zone was triggered.

F. RF reception indicator — ON while

any transmitter button is pressed.

G. Valet mode indicator — Flashes slowly

to indicate system is in valet mode.

H. Anti-Carjack — Rapid flashes to

indicate the system is in the anti-

carjack mode.

Appendix 3 — PROGRAMMABLE FEATURES

Appendix 2 — UNDERSTANDING THE LED FLASHES

Programmable features allow you to customize your alarm. Your dealer can program them when

the alarm is installed.

 Permanent chirp delete — Can permanently disable the siren’s chirps. See page 8.

 Passive/active arming — Alarm is default at active arming. Press the

I button to arm the alarm.

In passive arming, the alarm arms itself when you turn the ignition OFF and close the last

open door.

 Current sensing — Program the alarm for switch sensing only, or for both current and switch

sensing. Alarm is default at current and switch sensing.

 Ignition-controlled door lock and unlock — Can be set to lock and/or unlock the doors

automatically when the ignition is turned ON and/or OFF.

 Double Pulse Lock/Unlock — Alarm default is set at single pulse lock/unlock. Some vehicles

require a double pulse.

 0.5/3.5-sec. door lock/unlock time — Alarm default is set at 0.5 sec.

 SecureLock

(Automatic Locking) - If this feature has been enabled under the automatic

arming mode, then the doors will automatically lock once the alarm arms. See page 8

Notice: The changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements,

no change to the antenna or the device is permitted. Any change to the antenna or the device

could result in the device exceeding the RF exposure requirements and void user’s authority to

operate the device.

Summary of content (6 pages)

PAGE 1
ENFORCER 100LB/100CB Owner's Manual ENFORCER 100LB/100CB Owner's Manual Appendix 2 — UNDERSTANDING THE LED FLASHES A. Arming indicator — Flashes quickly during the 30-second rearm to show passive arming countdown. B. Door open indicator — OFF when a hardwired door is opened during the 30-second rearm or passive arming countdown. C. Armed indicator — Flashes when the alarm is armed. D. Disarmed indicator — OFF when the alarm is disarmed. E.
PAGE 2
ENFORCER 100LB/100CB Owner's Manual CONGRATULATIONS From the moment you purchased this ENFORCER Vehicle Security System, you became a part of the SECO-LARM family. You started taking advantage of over 34 years of advanced engineering. You joined a team of engineers, technicians, designers, and people like yourself who know how important protecting your car is. You discovered the SECO-LARM difference. This difference is important because the ENFORCER is more than just an alarm.
PAGE 3
ENFORCER 100LB/100CB Owner's Manual ENFORCER 100LB/100CB Owner's Manual TAMPER INDICATORS & TRIGGER ZONE ID TABLE OF CONTENTS If your alarm was triggered when you were away, the siren will chirp two times and the parking lights flash seven times when you disarm your alarm. The LED flashes in quick cycles to show where the car was violated as follows: Transmitter Functions ................................... ENFORCER 100LB or ENFORCER 100CB? .... Arming ..................................................
PAGE 4
ENFORCER 100LB/100CB Owner's Manual ARMING There are two different ways to arm your alarm. Tell your dealer which is best for you:  Active Arming Turn your ignition OFF. Close all the doors. Then press the I button. If the siren chirps and parking lights flash once, the alarm is fully armed and the doors lock.
PAGE 5
ENFORCER 100LB/100CB Owner's Manual ENFORCER 100LB/100CB Owner's Manual CHIRP DELETE (silent arm/disarm) SENSOR BYPASS There are times, especially at night, when you may not want to hear the siren chirps. There are 2 ways to delete chirps: This is useful if you know, based on experience, that your shock sensor (or other add-on sensors) will false trigger, such as when you park near a construction site. Silent Arm A.
PAGE 6
ENFORCER 100LB/100CB Owner's Manual ENFORCER 100LB/100CB Owner's Manual VALET TOTAL PROTECTION While your alarm is armed, your car is protected in the following ways:  Potential thieves or vandals will be warned by the flashing LED.  If a thief opens a door, the alarm immediately sounds the siren and flashes the parking lights for 30 seconds.