ST730P USER MANUAL ST730P USER MANUAL -Sigfox Back-up Tracking Device- Suntech International Ltd.
ST730P USER MANUAL The ST730P is a battery-powered mini tracker utilizing GPS, RF and Sigfox techonology. Tracking Device with RF shall normally be used for Presence function (configured as “slave”) and might be set in ERB Mode. With its holder, it is a waterproof (IP67 compliant) hard-cased device to be used for various purposed like an assent tracker or a personal tracker. It works autonomously with its built-in battery.
ST730P USER MANUAL 2. Tracking The device will send a tracking message at a defined interval. The customer can configure what time interval and the local location source. The location source can be GPS. In the case of GPS as the location source, the device will turn on or wake-up the GPS receiver 30 seconds before sending the message. If the time interval is greater than 1 (?) hour the GPS will be turned on 1 minute before.
ST730P USER MANUAL 7. Settings The device can be configured by using the Synctrak software or by RF. The RF possible configurations are limited and (TBD) 8. Battery The battery status can be checked at power up, when the device will show it for 1 minute using the battery LED, and if the device is ON by pressing the On/Off button for less than 2 seconds.
ST730P USER MANUAL GENERAL SPECIFICATION Battery Primary battery Li-SOCL2 4000mAh Motion Detection Built-in 3-axis Acceleration sensor Report Interval (1) Normal Mode: Every 6 hour / day (2) Emergency: ≈ 15min /day RF Presence Battery Life Time Every 15 min (1) 2 years with the report interval above on normal mode (2) 1 week on Emergency mode. Power Consumption Operating current Sigfox : 17 mA in Rx mode 200mA in Tx mode @ 22.
ST730P USER MANUAL Approval FCC, Sigfox certificate (TBD) RF TRANSCEIVER SPECIFICATION Modulation Type CSS(Chirp Spread Spectrum) Frequency band 902~928MHz Output power Maximum 20dBm Power Consumption 120mA at 20dBm @4V GPS RECEIVER SPECIFICATION Receiver Type 56-channel U-Blox 7 engine GPS&QZSS L1 C/A, SBAS : WAAS, EGNOS, MASA, Update Rate 10Hz Accuracy Position 2.5m CEP SBAS 2.
ST730P USER MANUAL * 2) Dependent on aiding data connection speed and latency * 3) Demonstrated with a good active antenna INSTALLATION, CONFIGURATION AND PROTOCOL Most important point is to install the unit horizontally in order to have the top cover to see the sky For the details of product handlings / installations, please refer to the attached pictures. Note 1 : Configuration or Parameter setting should be done before installation.
ST730P USER MANUAL FCC Part 15.19 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Part 15.21 Any changes or modifications (including the antennas) to this device that are not expressly approved by the manufacturer may void the user's authority to operate the equipment.
