ST215 User Manual Suntech International Ltd.
ST215 User Manual ST215 Installation Guide 1. Configure ST 215 in the Lab by using Setting Tool. Setting MUST be done with back up battery or external power. (12V) For the details of configuration, refer to the other document. 2. Decide the location of ST215 and GPS Antenna, and check the cable ways. Check whether the location of ST 210 is far away from other electric equipments. GPS Antenna must have a sky-view and must be far away from other antenna. 3.
ST215 User Manual 2. Insert the SIM card into the holder in the direction as shown above. *Caution: when inserting, make sure that the unit is in the disconnected from main power. 4. Connect GPS Antenna For avoiding ESD, installer must wear gloves 5. Connect Event Lines with relevant lines of vehicle.
ST215 User Manual ‘red’ line of Event cable - Connect the red line to 12 VDC /24 VDC Constant power of vehicle ‘black’ line of Event cable - Connect the black line to Ground of vehicle ‘blue’ line of Event cable - Connect the blue line to an ignition wire of vehicle Caution : Never connect the red & blue lines together to a constant power source “Yellow , green, white” lines of Event cable - For digital input lines *Green line is use for digital input or ADC input according to your order opti
ST215 User Manual - Output line For immobilizer Block Diagram for Immobilizer “Gray , purple ” lines of Event cable - These two lines are for optional function which is one of RS232, CAN, Input or Output as below 5
ST215 User Manual *Check if which function is selected. For RS232 Interface, Refer to the below 6.
ST215 User Manual BLUE LED- indicates GPRS status Refer to separate document for detail operation status. Communicate with control center for checking each Event Lines 7. Confirm start of commercial operation with financial department The device complies with Part 15 of the FCC Rules.