User's Manual

KM713A User Manual

Important Information

For Windows® XP and Windows® Vista operating system, you can use the

keyboard and moue immediately after plugging the dongle (receiver) into the USB

port. But the hotkey : ”Fn+F1”, ”Fn+F8”, ”Fn+F9”, ”Fn+F10”, ”Fn+F8”, ”Fn+F11” need

install driver.

Hardware Installation

1. Plug in the dongle into your available USB port.

2. Make sure the batteries of the keyboard and moue are installed correctly. Please

follow the polarity signs in the battery compartment.

3. Please make sure the power switch on the back of the mouse is switched to “ON”

before using the mouse. When not in use, please turn the power switch to “OFF”

for power saving.

ID Pairing Procedure

Keyboard mouse and dongle has paired when ship out. If it can’t work, please follow

the steps to process the ID pairing procedure.

1. ID pairing/connect button location:

Keyboard ID pairing/connect button on the bottom of the keyboard.

Mouse ID pairing/connect button on the bottom of the mouse.

2. After you plug the dongle into the USB port, please hold the keyboard and mouse

close to the dongle within 0.5M and press the “CONNECT” button over 5 second.

3. If ID pairing is successful, the LED on the dongle will bright 3 seconds.

4. If ID pairing is fail, please follow the steps above to pair ID.

Note:

-Make sure your PC is ON and running when doing the pairing procedure.

-You don’t have to pair ID again after changing batteries. If it can’t work, please follow

the steps above to pair ID.

PDF created with FinePrint pdfFactory Pro trial version http://www.pdffactory.com

PAGE 1
KM713A User Manual Important Information For Windows® XP and Windows® Vista operating system, you can use the keyboard and moue immediately after plugging the dongle (receiver) into the USB port. But the hotkey : ”Fn+F1”, ”Fn+F8”, ”Fn+F9”, ”Fn+F10”, ”Fn+F8”, ”Fn+F11” need install driver. Hardware Installation 1. Plug in the dongle into your available USB port. 2. Make sure the batteries of the keyboard and moue are installed correctly. Please follow the polarity signs in the battery compartment. 3.
PAGE 2
Driver Installation 1. Driver name: “HPBattery.exe”. 2. Dual click the “HPBattery.exe”. The driver icon will show at the right-bottom of the Windows system tray when the driver is loaded. 3.
PAGE 3
CAUTION This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the authority to operate equipment.