User's Manual

Bluetooth Touchpad

(EBT-203A / KST-S01BT / 19025)

User Manual

Important Information

For Windows® 8 operating system, you can use the keyboard immediately after

plugging the dongle (receiver) into the USB port.

Hardware Installation

1. Make sure the batteries of the keyboard is installed correctly. Please follow the

polarity signs in the battery compartment.

2. Please make sure the power switch on the back of the Touchpad is switched to

“ON” before using the Touchpad. When not in use, please turn the power switch

to “OFF” for power saving.

ID Pairing Procedure

• Now the radio connection between computer and Touchpad must beestablished

(Pairing). Press the keys “ Left Button + Right Button” and Power ON your

Touchpad simultaneously.

After 2 seconds pairing starts, the pairing LED is blinking.

Pairing can take several seconds and is finished, when the LED above

the trackball goes off.

Should the pairing process break off (LED goes off) without getting a

connection, try it again. Probably, it can be necassary to switch the rear

sliding switch off and on again.

• On your screen the Bluetooth assistent opens and shows

all Bluetooth devices, which are located near your computer.

Select your Touchpad and confirm with „Continue“.

• The Touchpad is still not identified, press „Continue“.

PAGE 1
Bluetooth Touchpad (EBT-203A / KST-S01BT / 19025) User Manual Important Information For Windows® 8 operating system, you can use the keyboard immediately after plugging the dongle (receiver) into the USB port. Hardware Installation 1. Make sure the batteries of the keyboard is installed correctly. Please follow the polarity signs in the battery compartment. 2. Please make sure the power switch on the back of the Touchpad is switched to “ON” before using the Touchpad.
PAGE 2
Note: -Make sure your PC is ON and running when doing the pairing procedure. -You don’t have to pair ID again after changing batteries. If it can’t work, please follow the steps above to pair ID. Import Usage Information Battery: 1. We recommend using alkaline batteries for a longer battery life. 2. Don’t mix different types of batteries or new and old batteries together. Always replaced old batteries with new and same type batteries. 3. Remove batteries after long periods of non-use.
PAGE 3
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help.