User's Manual

Bluetooth Keyboard

(BK022A)

User Manual

Important Information

For Windows® XP , Windows® Vista and Windows® 7 operating system, you

can use the keyboard immediately after plugging the dongle (receiver) into the USB

port.

Hardware Installation

1. Make sure the batteries of the keyboard is installed correctly. Please follow the

polarity signs in the battery compartment.

2. Please make sure the power switch on the back of the Keyboard is switched to

“ON” before using the Keyboard. When not in use, please turn the power switch to

“OFF” for power saving.

ID Pairing Procedure

• Now the radio connection between computer and keyboard must beestablished

(Pairing). Press the keys

Fn +F1 on your keyboard simultaneously.

After 2 seconds pairing starts, the pairing LED is blinking.

Pairing can take several seconds and is finished, when the LED above

the trackball goes off.

Should the pairing process break off (LED goes off) without getting a

connection, try it again. Probably, it can be necassary to switch the rear

sliding switch off and on again.

• On your screen the Bluetooth assistent opens and shows

all Bluetooth devices, which are located near your computer.

Select your keyboard and confirm with „Continue“.

• Type the shown in the menu pass key with your Bluetooth keyboard,

confirm with „Enter“ and go on with „Continue“.

• The keyboard is still not identified, press „Continue“.

PAGE 1
Bluetooth Keyboard (BK022A) User Manual Important Information For Windows® XP , Windows® Vista and Windows® 7 operating system, you can use the keyboard immediately after plugging the dongle (receiver) into the USB port. Hardware Installation 1. Make sure the batteries of the keyboard is installed correctly. Please follow the polarity signs in the battery compartment. 2. Please make sure the power switch on the back of the Keyboard is switched to “ON” before using the Keyboard.
PAGE 2
Note: -Make sure your PC is ON and running when doing the pairing procedure. -You don’t have to pair ID again after changing batteries. If it can’t work, please follow the steps above to pair ID. Import Usage Information Battery: 1. We recommend using alkaline batteries for a longer battery life. 2. Don’t mix different types of batteries or new and old batteries together. Always replaced old batteries with new and same type batteries. 3. Remove batteries after long periods of non-use.
PAGE 3
Industry Canada Notice Operation is subject to the following two conditions: (1) this device may not cause interference and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Industry Canada Caution This device complies with Industry Canada licence-exempt RSS standard(s).