JME-3140 (Presenter) JME-3271 (Dongle) User Manual
HOW TO USE THE LASER PRESENTER 1. Insert the receiver into the USB port of PC. 2. Your PC operation system will start to install the device automatically .And you can see the information as below display in your computer. 3. In Win98/Me operation system you need to follow the instructions on your screen .During the install process, the O/S may ask you to put Win98 CD into the CD-ROM. 4. After the installation process is done,the presenter will start working . Better than other competition: 1. 2. 3. 4. 5.
F5 / Esc Page Up Page Down Trackball Mouse Left Button Mouse Right Button Laser Button Notice : For trouble shooting If the presenter is not working : 1. Maybe the battery power is too low , please check your battery . 2. Maybe ID code was not matched ,please link ID. (1)Make sure receiver connector plug into correct port. Receiver port should plug into PC USB port. For the best efficiency, keep the receiver 30 cm distance with Laser Presenter (2).
Specifications Electrical/Presenter Interface USB Buttons Laser (1), Function (4) Channel Number 74 CH ID Number 2^32 Input power AAA batteries (1.5 Volt, DC) Transmission Radio Frequency Modulation frequency 2.402 – 2.478GHz Effective distance Up to 33 feet (10 m ) Power consumption – 95mA (Max) Standby Mode 0.4 mA Compatibility Fully Compatible with PC/AT Compatibility software Windows® 98/Me/2000/XP operating system Laser wavelength at peak emission 645-665 nm Laser Spot size at 16.