User's Manual

Wireless Mouse Manual
Introduction
Congratulation on your purchase of the Sunrex wireless mouse. The mouse
combine RF and new optical technology, reduce the tolerance of clean mouse ball and
wire mouse interference. You can use mouse freely and conveniently within 1.2 meters.
Note:
The actual effective distance may increase or decrease depending on the
surrounding environment.
System Requirements:
To use the mouse, your computer must meet the following hardware requirements and
run one if the operating systems listed below.
Hardware:
PC with and Intel Pentium processor or equivalent and a hard disk drive
64MB RAM or higher, depending on the operating system
USB interface
Operating System:
Windows 98/Me/2000/XP
Connecting the receiver and installing the default driver
To connect the receiver to your computer, plug the standard USB end of the
receiver into an available USB port on your computer. Alternatively, you can use the
supplied USB extension cable to connect the receiver to your computer for an additional
0.45m of length.
Your computer’s operating system identifies the receiver a “USB Human
Interface Device” and begins installing the default driver. Follow any on-screen
procedure to complete the default driver installation.
Note:
If you are running the Windows 98/Me operating system, you may be prompted to insert
the Windows CD-ROM that came with your computer. You are now ready to begin using
the wireless mouse.
Specification
Power Supply: 3 AAA batteries
Rechargeable Distance: 1.2M
Interface: USB 1.1
Radio Frequency: 27.01MHz
Security ID Code: 256ID
Button: 3 buttons (with wheel)
Resolution: 800dpi
Dimension: 125*97*42.5mm
Compatible system: Windows 98/Me/2000/XP

Summary of content (3 pages)