INSTRUCTION MANUAL HOT WATER DISPENSER WITH DUAL-PUMP SYSTEM Models: SP-3201 (3.2 Liters) SP-4201 (4.2 Liters) Thank you for purchasing this appliance. Read all instructions carefully before use.
The important information, herein, is intended to prevent possible injuries and damage to the appliance. Please follow accordingly. Parts Introduction General Safety Precautions Always unplug appliance from the main electrical supply outlet before cleaning or when not in use. Always attach the power cord to the appliance BEFORE you plug it to the main electrical supply. To disconnect appliance, grasp the plug to remove, do not pull on the cord.
-2-
Technical Specifications Model Voltage Power Capacity SP-3201 120V~ 700W 3.2L SP-4201 120V~ 700W 4.2L Specifications are subject to change without prior notice with the development of technology. Before Using 20. 21. 22. 23. 24. 25. 26. 27. 28. Point steam away from power point switch and furniture. Keep flammable materials away from appliance. Handle power cord carefully as cord may malfunction if dropped.
Using the dispenser for the first time 1. 2. 3. 4. 5. 6. 7. Wash and rinse inner tank with water. Fill water up to full line. Boil once and discard water by pumping it out. Open top lid and add water Pull up on the lid lock and open top lid. Fill with cold water from another container, such as a kettle or pitcher. Do not fill directly under faucet. To prevent overflow, do not fill above the maximum mark. Be careful not to splash water onto the control panel.
Important Guidelines A short power cord is provided to minimize the hazards involved with tripping over longer cords. Longer extension cords can be purchased and used with this appliance, however one should exercise care and caution. The extension cord should have 1) a minimum acceptable marked electrical rating similar to that of the appliance, 2) should be a grounded three-prong plug and 3) should be arranged so that it will not drape over counter top or table top where it can be easily pulled or tripped.