User's Manual

ELECTRONIC BALLAST INSTALLATION INSTRUCTION

SUNPARK ELECTRONICS CORP.

Model : 120-3/32IS MPF

CAUTIONARY NOTES: Do not use this equipment for other than intended use.

1. Verify that the line voltage matches the ballast voltage.

2. Installation to be made by a qualified person in accordance with applicable codes.

Warning

This product may cause interference to radio equipment and should not be

installed near maritime safety communications equipment or other critical

navigation or communication equipment operating between 0.45-30 MHz.

Features

z 120V AC input

z Mid Power Factor

z Class P

z Sound rating A

z UL, cUL recognized. File E177888

z Indoor / outdoor use.

Lamp type & power consumption :

Lamp Input Power

T8 32W x 3 85W

T8 25W x 3 65W

T8 18W x 3 48W

T8 17W x 3 46W

T8 15W x 3 38W

T12 40W x 3 72W

T12 34W x 3 60W

T12 25W x 3 67W

Before installation

1. Disconnect line voltage before installing or replacing lamp.

2. Ballast case must be grounded.

3. Place the ballast to a stable support and fix it.

Installation

1. Connect the lamps to the ballast according to the label . Ballast supports only the

type of lamps specified on the product label.

2. Connect the AC power line. Connect the black wire to L terminal and white wire

to N terminal of the AC source.

3. Connections of power wires must be fully insulated.

PAGE 1
ELECTRONIC BALLAST INSTALLATION INSTRUCTION Model : 120-3/32IS MPF CAUTIONARY NOTES: Do not use this equipment for other than intended use. 1. Verify that the line voltage matches the ballast voltage. 2. Installation to be made by a qualified person in accordance with applicable codes. Warning This product may cause interference to radio equipment and should not be installed near maritime safety communications equipment or other critical navigation or communication equipment operating between 0.45-30 MHz.