K1 Kiosk User Manual Book Before using this product, please read carefully this instruction manual and keep it properly.
Quick Install Guide Minimalist Setting Enable the smart commercial device, which only needs several steps 1 After turning on the complete machine power supply, the screen will be lit and you will enter the first boot interface, and just simply operate according to the instructions. There are above two types of Internet surfing modes available for the local machine to choose. 2 Wi-Fi setting · Click “Setting” button, then enable WLAN, enter WLAN search interface.
Brief Introduction of Self-Checkout Kiosk Face camera Integrated touch display screen Protection cover on the mainboard Wired network interface Key for panel power supply interface Key for panel power switch Key for panel key hole Paper exit of the printer Bar code scanning port System on-off key Face camera Bar code scanning port Protection cover on the mainboard Wired network interface Camera used to shoot human face. Used to scan the bar codes of the goods or mobile phones. Inside the machine.
Paper Loading Steps of the Printer of Self-Checkout Kiosk Three Types of Installation Methods Available for K1 Self-Checkout Kiosk 1 3 2 4 2 1 Open the host panel Open the host panel with key. 3 Install the printing paper Place inward 80 mm thermal sensitive paper and pull out a section outside the printer port. 2 Open the printer bin gate Toggle downward the printer driving lever and open the printer bin gate.
Installation Steps of wall mounting type complete machine 136 1096 196 1 Install the wall-mounted rack Drill holes according to the height described in the reference drawing. Firmly fix the wall-mounted rack onto the wall surface. 2 Install the rear mounted pieces of the host Assemble the rear mounted pieces of the host onto the back side of the host. 3 Mount the host well Mount the host onto the wall-mounted rack.
Installation Steps of Vertical Type Complete Machine Upright post Table bracket Left side stainless steel table Cross beam Right table Base plate 1 Install the upright post Install the upright post onto the base plate. 2 Install the left side table bracket Assemble the table support member onto the upright post. 3 Install the left side table Assemble the left side stainless steel table onto the table bracket.
Installation Steps of Desktop Type Complete Machine fixed 1 Assemble the desktop bracket Assemble the desktop bracket into an assembly. 6 Install the fixed mounting elements 7 Mount the host onto the upright post Pass the power line & network cable through the cabinet opening, and plug in the plug at the host end. The camera height after installation is suggested to be 1620 mm above the ground. 2 Install the bracket Hold the host screen downward, install the desktop bracket onto the host backboard.
Basic Parameters of Self-Checkout Kiosk Operating system Android 7.1 Processor Rockchip RK3288 Storage Memory:2GB; store:16GB + TF card extension Display screen 21.5’ TFT-LCD display screen, resolution: 1920*1080 Touch screen Ten point touch control capacitive screen WIFI Single frequency 2.4G, support 802.11b/g/n Bluetooth Support Bluetooth 4.
Name & Content Identification Table of This Product’s Toxic & Harmful Substance Points for Attention Toxic and harmful substances and elements Name of parts (Pb) (Hg) (Cd) (Cr(VII) (PBB) (PBDE) Circuit board Shell :It indicates that the content of toxic and harmful substances in all homogeneous materials of this part is below the limit specified in SJ/T11363-2006.
FCC Regulations: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.