Configure Settings. Initial Settings: Please perform “CLEAR ALL SETTINGS” step to make sure all cards add by you. (Please ref CLEARN ALL SETTINGS step) A. Register User Card: 1. Press “Learning Card Button” (Right side BLACK button) 2. Into “Register User Card Mode” (you will get Beep sound) 3. Press four (4) digits display on Touch PIN panel. (The sequence of 4 digits is not problem) 4. Take User Card near the proximity area. (you will get a Beep sound) 5. Repeat step 2 & 3. 6. Register User Card Complete.
sounds is long beep for two time d. When registering User PIN code, the code must be entered within 10 seconds. If time expires, no code is registered and the process must be re‐start for Registering User PIN code. e. Quit “Learning PIN code mode”: Press “Learning PIN code Button” again. f. Max User PIN codes are thirty two (32) set of PIN codes. g. One User Card can only assign one set of PIN code available. C. CLEAR ALL SETTINGS: 1. Hold on “Learning Card Button”(BLACK button) for ten(10) seconds.
K. De‐Active Security Mode: ref Unlock function. L. Emergency Power Supply 1. 9V battery connections are lock under the front of the outside lock. (bottom of outside lock) In the case that the four (4) AAA alkaline batteries are completely discharge; a 9V battery can be used to supply power for temporary operating lock. While connecting the 9V battery, the lock can be operated as normal, thus granting access so the four (4) AAA alkaline batteries can be replace. 2.
Federal Communication Commission interference Statement : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.