User's Manual
Installation/Operating Instructions
READ THESE INSTRUCTIONS BEFORE FIRING UP YOUR BALLAST
WARRANTY This unit, when properly used will provide you with years of service.
It is covered under a 3 year warranty. This warranty will be voided if the unit is
misused, abused or altered. Warranty repair or replacement will be at the sole
discretion of the manufacturer. Defective units need to be returned to the place
of purchase with proof of purchase/receipt.
This warranty is expressly in lieu of all other warranties, expressed or implied,
including the warranties of merchantability and fitness for use and of all other
obligations or liabilities on the part of the seller. This warranty shall not apply
to this product or any part thereof which has been damaged by accident, abuse,
misuse, modification, negligence, alteration or misapplication. Manufacturer
makes no warranty whatsoever in respect to accessories or parts not supplied by
manufacturer. This warranty shall apply only to the United States, including Alaska,
Hawaii and territories of the United States and Canada. This warranty does not
cover labor materials, travel time, equipment, etc. to de-install any lighting fixtures
or other equipment.
RETURNING UNITS Please contact your retail store for returns.
KEEP ORIGINAL PACKAGING— all returns need to be in the original packaging
in order to avoid product damage during shipping. Any damage to products not in
their original packaging will not be covered under warranty.
SAFETY FIRST! Failure to observe the following safety warnings may result in
serious injury. In addition, failure to observe these safety warnings will result in a
waiver of all liabilities and will void all warranties.
WARNING
If the exterior of the lamp is damaged, replace lamp immediately.
When re-lamping, make sure lamp has time to cool before touching.
Make sure reflector sockets are in the closed position—properly securing
the lamp.
Make sure power cord and lamp cord are connected properly.
Disconnect power before re-lamping.
DO NOT hang by power or lamp cord.
DO NOT make contact with the interior of the socket while power is on.
DO NOT operate light systems in wet locations.
DO NOT plug system into supply voltage other than what is designated on ballast.
DO NOT attempt to rewire or reconfigure your system, it will void warranty and
could cause serious safety hazards (i.e. power cord, lamp cord, lamp socket or ballast).
Keep away from children.
Galaxy DE:
902682 - 1000 WATT 120/240
902685 - 1000 WATT 240 ONLY
902684 - 1000 WATT 277 ONLY
OPTIMIZED FOR
DOUBLE ENDED LAMPS
Part 18 compliance This device complies with Part 18 of the FCC Rules.
Advisory statement
This product may cause interference to radio equipment and
should not be installed near maritime safety communications
equipment or other critical navigation or communication
equipment operating between 0.45-30 MHz.
The interference potential
of the device or system
The interference potential of the device or system is the
operating frequency; 110 kHz.
Maintenance of the system Unplug the unit, wait 30 seconds, and plug the unit back in.
Simple measures that can be taken
by the user to correct interference
Move the unit away from any radio device.
This product contains delicate electronic components. This means that if it is
placed near an object that transmits radio signals, it could cause interference. This
could be, for example, mobile telephones, walkie talkies, CB radios, remote con-
trols and microwaves. If interference occurs, move such objects away from
the appliance.
Galaxy DE Select-A-Watt 600/750/875/1000/Turbo Charge 120/240 Volt:
FCC#: 2AEHV902682