Quick Start Guide

ManualsBrandsSunBriteTV ManualsAccessoriesSB-HDWT HD Wireless Device with Built In IR Extender Which Supports up to 1080P Resolutions, 30 Meters Line of Sight

Quick Start Guide

SB-HDWT Wireless HD Transceiver

Thanks for purchasing the SunBriteTV SB-HDWT wireless HD

transceiver! Now let’s get it working.

We’re going to start by doing a quick test of the system to make

sure all the connections and components in the system are

working correctly before you install them permanently.

Summary of content (4 pages)

PAGE 1
Quick Start Guide SB-HDWT Wireless HD Transceiver Thanks for purchasing the SunBriteTV SB-HDWT wireless HD transceiver! Now let’s get it working. We’re going to start by doing a quick test of the system to make sure all the connections and components in the system are working correctly before you install them permanently.
PAGE 2
Step 1: Connect the transmitter Start with the HDWT-Tx transmitter, which is the smaller of the two components in the system. You can lay it flat or mount it upright on its stand. Make sure it’s placed a couple of feet away from the other electronics. Connect the included 6-foot HD cable to the back of the transmitter, then to the HD output of a Blu-ray player, DVD player, cable box or satellite receiver. Make sure the device is powered up and playing.
PAGE 3
Step 3: Make sure it’s working The TV screen should display “Connecting to SB HDWT,” then your program should appear on the screen. If the screen isn’t showing the picture from the DVD player, cable box, etc., check these things in order: 1) Check if all three lights on the front of the transmitter and two lights on the receiver are on. If they’re not, check the power and video connections. 2) Make sure the TV is turned on and the proper HD input is selected.
PAGE 4
Step 5: Install the receiver Take one of the included rubber grommets and push it around the 15-foot HD cable near where it enters the receiver. Move the grommet to where it aligns with the slotted plastic piece on the underside of the receiver, and slide it in so the plastic pieces enters the groove around the grommet. Repeat this with the AC power cable going into the receiver. Replace the cover, making sure that it fits into the grooves around the grommets, and secure it with the retaining screw.