purifying fountain Model SBCF01 INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS WARNING: When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock and/or injury to persons, including the following: • Read all instructions before using the appliance. • To reduce the risk of injury, closer supervision is necessary when an appliance is used near children. • To protect against electric shock, DO NOT place the cord or AC Adapter in water or other liquids.
Product Overview: Water tank tank cap Top of lid nozzle AC Adaptor Filter slot Charcoal Filter cartridge BASE CORD PUMP Particle Filter cartridge Bottom of lid 2
Operating Instructions: Please read ALL of the instructions in this manual carefully before you begin to use this appliance. Proper care and maintenance will ensure a long life and a trouble-free operation for this appliance. Please save these instructions and refer to them for cleaning and care tips. DO NOT RUN DRY. 1 Before use, check the electrical cord for any tears or damage before use. 2 Connect the electrical cord to the AC adaptor.
7 Place the fountain in a desired Pump location. Use a water resistant mat to help protect your floor from splashing or dripping from your pet. 8 Make sure the pump is mounted to the lid. (figure D) 9 Attach the lid to the base and press figure D down until the lid is secure. Make sure the electrical cord is held snugly in the notch in the back of the lid. (figure E) 10 Fill the tank with water and twist the cap onto the tank. DO NOT over tighten.
Helpful Tips: NOTE - When introducing your pet to the fountain your pet might be cautious and need some time to get used to the new water fountain. Here are a few tips to help ease your pet into the use of the fountain. • DO NOT remove your pet’s current water source. • DO NOT plug in the water fountain for a few days. This will allow your pet to get used to the new fountain without the noise of the pump and the splash from the water stream.
Fountain Cleaning: The fountain should be cleaned once a week to maintain normal function. 1 Unplug the fountain, remove the water tank and lid, and remove the filters. DO NOT unplug by pulling on cord. To unplug, grasp the AC Adapter, not the cord. 2 Empty the water from the base and water tank. 3 Clean the base, water tank, and cap in a solution of warm water and mild liquid soap. Never use abrasive cleansers, steel wool pads or other abrasive materials. Rinse well.
1 Year Warranty In the U.S.A. and Canada If you have any question regarding this warranty or would like to obtain warranty service, please call 1-866537-2249 and a convenient service center address will be provided to you. Sunbeam Products, Inc.