bs 1107 IMPORTANT SAFETY INSTRUCTIONS *" When using electrical appliances, basic safety precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING Lighted Lamp is HOT WARNING ~— To reduce the risk of FIRE, ELECTRIC SHOCK, EXPOSURE TO EXCESSIVE UV, RADIATION , OR INJURY TO PERSONS : 1. Turn off / unplug and allow to cool before replacing lamp. 2. Lamp gets HOT quickly! Only contact switch / plug when turning on. 3. Do not touch hot lamp containment barrier . 4.
41107 15 FER 2008 Reorient or relocate the receiving antenna, Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio TV technician for help. Note: This product may cause interference to radio equipment and should not be installed near maritime safety communications equipment or other critical navigation or communication equipment operating between MHz.
41107 Assembly 15 FEB 2005 Attach the spacer by screwing it into the top of the base. «Connect the lamp/bulb into the lamp socket. Pushing the bulb into the lamp socket clamp and then into the clamp on the opposite side. Place the lampshade onto the spacer and secure it by screwing on the lampshade cap. Lampshade Cap Operation 1. Plug the Jap into a 110-120V power outlet. 2. Tum the power control knob slightly clockwise to the maximum brightness setting. 3.
bg 1107 15 FER 2005 Lamp Replacement Replacement lamp bulbs are available from the sharper Image. Call and order item bomber S1929. Lift the lamp / bulb from the clamp opposite the socket and pivot upward. Pull the remaining side out from the socket and clamp. Reverse the procedure in install the new lamp/bulb.