42404 30 MAY 2005 IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances, basic safety precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING Lighted Lamp is HOT WARNING — To reduce the risk of FIRE, ELECTRIC SHOCK, EXPOSURE TO EXCESSIVE UV, RADIATION, OR INJURY TO PERSONS: 1, Tum off / unplug and allow to cool before replacing lamp. 2. Lamp gets HOT quickly! Only contact switch / plug when turning on. 3. Do not touch hot lamp containment barrier. 4.
may 2005 Reorient or relocate the receiving antenna, Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio TV technician for help, Note: This product may cause interference to radio equipment and should not be installed near maritime safety communications equipment or other critical navigation or communication equipment operating between MHz.
Mob 2404 30 MAY 2005 Assembly 1 Remove the plastic packing materials from the ght fixture 2. Remove the foam shipping guard from unbend the per-mstalled Lang. Note : The lamp socket pivots out. Be certain to push the lamp and zonked Figure A below.) Figure A 3. To adjust tie lamp height and angle, loosen the knobs on the fissure ams o 10 the desired height and angle. then tighten the knobs to seems the new 1 Operation 1. Plug the lamp into a 110-120V power outlet. 2.
Lamp Replacement 1. The lamp and socket pivot out for easy replacement. Gently pull the lamp out and slide the lamp out of the fixture socket. (See Figure C below.) [re em TT Figure C 2. Replace with a new lamp. Replacement lamps are available from The Sharper Image (Item No.81928). Do not use any other lamp with this product. 3. Gently push the lamp and socket back into place. (See Figure D below.