COLD CAVERN® BEER FROSTER Models: ALFZ37BFROST ALFZ37BSSTBFROST User Manual BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS FELIX STORCH, INC. An ISO 9001:2015 registered company 770 Garrison Avenue Bronx, NY 10474 www.summitappliance.
TABLE OF CONTENTS Appliance Safety 3 Important Safeguards 3-4 Installation Instructions 5-8 Before Using your Appliance 5 Installing your Appliance 5 Electrical Connection 5-6 Extension Cord 6 Reversing the Door Swing 6 Installing the Handle 7 Operating your Beer Froster 7-9 Control Panel 7-8 Defrosting 9 Shelves 9 Care and Maintenance 10 Cleaning your Appliance 9 Power Failure 9 Vacations 9 Moving your Appliance 9 Energy-Saving Tips 9 Troubleshooting 10 Limited Warra
APPLIANCE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. The symbol alerts you to potential hazards that can kill or injure you and others. All safety messages will follow the Safety Alert Symbol and either the word DANGER or WARNING.
• • • • • • • • • • • • • • • • • • In the event of any damage: o Avoid open flames and anything that creates a spark, o Disconnect from the power supply, o Air the room in which the appliance is located for several minutes, and o Contact the Service Department for advice. The more coolant there is in an appliance, the larger the room it should be installed in. In the event of a leakage, if the appliance is in a small room, there is the danger of combustible gases building up.
INSTALLATION INSTRUCTIONS Before Using your Appliance • • • • Remove the exterior and interior packing. Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. Clean the interior surface with lukewarm water using a soft cloth. Install the handle on the door, if it is not already attached. (See page 8.
This appliance requires a standard 115/120 Volt AC ~60Hz three-prong grounded electrical outlet. Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet. To prevent accidental injury, the cord should be secured behind the appliance and not left exposed or dangling.
Installing the Handle Some units include a handle, which you may want to install. The handle is not required to operate the unit. To install the handle, follow the instructions below: 1. Use a screwdriver to remove the screws on the side of door where the handle is to be installed. 2. Align the handle with the screws removed in step # 1. Tighten the screws using a Phillips head screwdriver until the handle is both flush and secured tightly against the door side.
• Press and hold the SET and the LIGHT keys for three seconds to turn the unit on/off/ • • Press the key to view the temperature To adjust the temperature, press and hold the SET key for 3 seconds. When the display shows St, you can raise the temperature by pressing the LIGHT key or lower it by pressing the MENU ADJUST key, shown below. Press the key, or press no key for 30 seconds, to exit. The temperature set-point will be saved automatically.
Alarms Various alarms will sound under certain conditions if the unit’s buzzer is enabled. Below is a table listing the unit’s alarm codes and causes: Alarm Code E1 E2 E3 cH rH rL Causes Cabinet temperature sensor fails. Evaporator sensor fails. Condenser sensor fails. High condenser temperature alarm High cabinet temperature alarm Low cabinet temperature alarm Defrosting Freezer models and the freezer compartment of refrigerator-freezers require manual defrosting.
CARE AND MAINTENANCE Cleaning your Appliance • • • • • Turn off the power, unplug the appliance, and remove all items, including shelves. Wash the inside surfaces with a solution of warm water and baking soda (about 2 tablespoons of baking soda to a quart of water). Wash the shelves with a mild detergent solution. Wring excess water out of the sponge or cloth when cleaning the area where the controls are located, or any electrical parts. Wash the outside cabinet with warm water and mild liquid detergent.
TROUBLESHOOTING You can solve many common problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. PROBLEM Appliance does not operate. POSSIBLE CAUSE Appliance is not connected to a power supply. The appliance is turned off. Tripped circuit breaker or a blown fuse. The temperature is not set correctly. The ambient temperature could require a lower temperature setting. The door was opened too often.
LIMITED WARRANTY ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory-specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company. Outside the 48 states, all parts are warranted for one year from manufacturing defects.