SUMMIT SEMICONDUCTOR LLC AUDIO WIRELESS CLIENT DEVICE SUMMIT SEMICONDUCTOR LLC Model No.: 444-2213 FCC ID: UA9400 USER MANUAL Issue Date: 27 October, 2011 Revision: 1.0 Revision History Rev. No. 1.0 History Draft Release Model No. 444-2213 www.summitsemi.com Issue Date 27 October, 2011 Remarks Pending FCC Grant 22867 NW Bennett St.
SUMMIT SEMICONDUCTOR LLC AUDIO WIRELESS CLIENT DEVICE COPYRIGHT 2010 SUMMIT SEMICONDUCTOR LLC ALL RIGHTS RESERVED THE MATERIAL CONTAINED IN THIS DOCUMENT IS PROTECTED BY COPYRIGHT LAWS OF THE UNITED STATES OF AMERICA AND OTHER COUNTRIES. IT MAY NOT BE REPRODUCED OR DISTRIBUTED IN ANY FORM BY ANY MEANS, ALTERED IN ANY FASHION, OR STORED IN A DATA BASE OR RETRIEVAL SYSTEM, WITHOUT EXPRESS WRITTEN PERMISSION OF SUMMIT SEMICONDUCTOR LLC.
SUMMIT SEMICONDUCTOR LLC AUDIO WIRELESS CLIENT DEVICE Table of contents 1.0 Regulatory Statement …………………………………………………...4 1.1 FCC Certification…………………………………………………4 2.0 Introduction……………………………………………………………...5 3.0 Installation and Test procedure……………………….…………………8 3.1 Boot 3.2 Setting frequency channel, data rate and transmit power 3.3 Stop Transmitting 4.0 System Requirements…………………………………………………..13 Model No. 444-2213 www.summitsemi.com 3 of 11 © 2010 Summit Semiconductor LLC 22867 NW Bennett St.
SUMMIT SEMICONDUCTOR LLC AUDIO WIRELESS CLIENT DEVICE 1.0 Regulatory Statement The United States Federal Communication Commission has established certain rules governing the use of electronic equipment. 1.1 FCC Certification This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
SUMMIT SEMICONDUCTOR LLC AUDIO WIRELESS CLIENT DEVICE 2.0 Introduction: The 444-2213 Wireless Audio Client device is a production ready module designed for active speakers in Summit Semiconductor’s wireless audio technology. The module mounts to the top interior wall of a typical speaker. The module includes a patented, low cost, high gain quad diversity PCB antenna integrated in the module to provide superior wireless performance without external antennas.
SUMMIT SEMICONDUCTOR LLC AUDIO WIRELESS CLIENT DEVICE BACK SIDE CAUTION: DO NOT TRY TO REPLACE THE ANTENNAS Model No. 444-2213 www.summitsemi.com 6 of 11 © 2010 Summit Semiconductor LLC 22867 NW Bennett St.
SUMMIT SEMICONDUCTOR LLC AUDIO WIRELESS CLIENT DEVICE 3.0 Installation and Test Procedure A host interface board is used to provide the necessary regulated power supply to the 444-2213 Wireless Audio Client device. The set up is as shown in the picture below. 7 6 5 1 4 2 3 Model No. 444-2213 www.summitsemi.com 7 of 11 © 2010 Summit Semiconductor LLC 22867 NW Bennett St.
SUMMIT SEMICONDUCTOR LLC 1 2 3 4 5 6 7 AUDIO WIRELESS CLIENT DEVICE Wireless Audio Client device Integrated Antenna RF Can Mikkalo(Interface Board) Reset Button Power Input 3.3V RS232 interface 3.1 Boot: . Download Summit Semiconductor’s Hood_BIST_156 software onto your computer. Connect Mikkalo (interface board) to 444-2213 Wireless Audio Client device as shown in the picture. Connect a 3.3V DC supply to Mikkalo (interface board) from a variable or a fixed source.
SUMMIT SEMICONDUCTOR LLC AUDIO WIRELESS CLIENT DEVICE 3.2 Setting Channel, data rate and transmit power The following transmit command is used to set the transmitter in a particular channel and to start transmitting. tx -1 1 d 4 8 255 The parameters in the command are explained below. ‐1 1 d 4 8 255 Model No. 444-2213 www.summitsemi.
SUMMIT SEMICONDUCTOR LLC AUDIO WIRELESS CLIENT DEVICE Please refer the table below to change frequencies in the transmit command.
SUMMIT SEMICONDUCTOR LLC AUDIO WIRELESS CLIENT DEVICE The following command is used to stop the DUT from transmitting. stoptx 4.0 System Requirements Operation: PC with COM ports Programming: Windows XP and higher Model No. 444-2213 www.summitsemi.com 11 of 11 © 2010 Summit Semiconductor LLC 22867 NW Bennett St.