User's Manual

ManualsBrandsSummit Data Communications ManualsElectronics802.11a/g/draft 802.11n WLAN PCI-E Minicard

Hardware Integration Guide – SDC-PE15N

13 SDC-PE15N_HIG1.0

Regulatory

Note: Operation in the 5150-5250 MHz band is limited to indoor use only.

Certified Antennas

The SDC-PE15N provides two Hirose U.FL type antenna connectors to support transmit and receive

diversity. For single antenna, non-diversity applications, OEMs are advised to use the Main (not Aux)

antenna connector and should disable transmit and receive diversity from the Global tab of the Summit

Client Utility (SCU) software utility.

The SDC-PE15N has been tested to the regulatory standards defined in the “Certifications” section of the

Specifications table above. These tests were conducted with the following antennas:

Summit SDC-CF22G Antenna

(click for datasheet)

 Form Factor: Chip Antenna on PCB

 Type: Dipole

 Maximum 2.4 GHz Gain: 0 dBi

Cisco AIR-ANT 4941

(click for datasheet)

 Form Factor: Whip

 Type: Dipole

 Maximum 2.4 GHz Gain: 2.2 dBi

 Tested and Certified 2.4 GHz Transmit Power: 90% of maximum setting (power must be reduced

to 90%)

Radiall Larson Dipole

(click for datasheet)

 Form Factor: Whip

 Type: Dipole

 Maximum 2.4 GHz Gain: 1.6 dBi (not used during testing)

 Maximum 5 GHz Gain: 5 dBi

HUBER+SUHNER

(click for datasheet)

 Form Factor: Whip

 Type: Monopole

 Maximum 2.4 GHz Gain: 3 dBi

 Maximum 5 GHz Gain: 6.5 dBi

 Tested and Certified 2.4 GHz Transmit Power: 95% of maximum setting (power must be reduced

to 95%)

 Tested and Certified 5 GHz Transmit Power: 100% of maximum setting (no reduction of power is

required in the 5 GHz band)

Summary of content (8 pages)

PAGE 1
Hardware Integration Guide – SDC-PE15N Regulatory Note: Operation in the 5150-5250 MHz band is limited to indoor use only. Certified Antennas The SDC-PE15N provides two Hirose U.FL type antenna connectors to support transmit and receive diversity. For single antenna, non-diversity applications, OEMs are advised to use the Main (not Aux) antenna connector and should disable transmit and receive diversity from the Global tab of the Summit Client Utility (SCU) software utility.
PAGE 2
Hardware Integration Guide – SDC-PE15N Antennas of differing types and higher gains may be integrated as well. With the Summit Manufacturing Utility software utility, OEMs may reduce the transmit power of the SDC-PE15N to account for higher antenna gain when necessary. In some cases, OEMs may be able to reduce certification efforts by using antennas that are of like type and equal or lesser gain to the above listed antennas.
PAGE 3
Hardware Integration Guide – SDC-PE15N persons and must not be co-located or operating in conjunction with any other antenna or transmitter.” Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 4
Hardware Integration Guide – SDC-PE15N Industry Canada User’s Guide Requirements As outlined in the Operational Description, the SDC-PE15N complies with Industry Canada (IC) rules for a Limited Modular Approval. To leverage Summit’s grant, the two conditions below must be met for the host device into which the SDC-PE15N is integrated: 1. The antenna is installed with 20 cm maintained between the antenna and users. 2.
PAGE 5
Hardware Integration Guide – SDC-PE15N  Type: Dipole  Maximum 2.4 GHz Gain: 2.2 dBi  Tested and Certified 2.4 GHz Transmit Power: 90% of maximum setting (power must be reduced to 90%) Radiall Larson Dipole  Form Factor: Whip  Type: Dipole  Maximum 2.4 GHz Gain: 1.6 dBi (not used during testing)  Maximum 5 GHz Gain: 5 dBi HUBER+SUHNER  Form Factor: Whip  Type: Monopole  Maximum 2.4 GHz Gain: 3 dBi  Maximum 5 GHz Gain: 6.5 dBi  Tested and Certified 2.
PAGE 6
Hardware Integration Guide – SDC-PE15N Electromagnetic compatibility and Radio spectrum Matters (ERM); Wideband Transmission systems; Data transmission equipment operating in the 2,4 GHz ISM band and using spread spectrum modulation techniques; Harmonized EN covering essential requirements under article 3.2 of the R&TTE Directive  EN 301 489-1 V1.6.
PAGE 7
Hardware Integration Guide – SDC-PE15N nimetatud direktiivist tulenevatele teistele asjakohastele sätetele. English Hereby, [name of manufacturer], declares that this [type of equipment] is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.
PAGE 8
Hardware Integration Guide – SDC-PE15N Slovensky [Slovak] [Meno výrobcu] týmto vyhlasuje, že [typ zariadenia] spĺňa základné požiadavky a všetky príslušné ustanovenia Smernice 1999/5/ES. Suomi [Finnish] [Valmistaja = manufacturer] vakuuttaa täten että [type of equipment = laitteen tyyppimerkintä] tyyppinen laite on direktiivin 1999/5/EY oleellisten vaatimusten ja sitä koskevien direktiivin muiden ehtojen mukainen.