Fitting Instructions

ManualsBrandsStyling city industries ManualsElectronicsWireless Plug-In Receive

Remote Control Wall Socket

Model: WRC-101

The Remote Control Wall Socket consists of two separate units: -

1. Remote Control Unit (Transmitter)

2. Wall Socket Unit (Receiver)

These units are completely self-contained and no wiring between them is necessary.

Fitting Instructions

It is important to install this product in accordance with the fitting instructions below. Failure to do so

may render your guarantee void.

IMPORTANT: PLEASE RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE WHEN

REPLACING BATTERIES

1) Before commencing work, you will require a drill and cross-headed screwdriver.

2) 1 x 3.0v batteries (CR-2032 – included)

3) Avoid positioning on UPVC or Metal Frames.

4) Avoid positioning above heat sources such as radiators or in damp areas such as a kitchen or

bathroom.

Fixing screws and wall plugs are supplied with this kit.

Pressing the Remote Control sends a wireless signal which activates the Wall Socket. The operating

range is 30-50m (99-165ft, indoor) and you can use the Wall Socket virtually anywhere in the home.

However, the transmission range will be reduced if the signal is transmitted through a number of

walls or ceilings and Metal partition can also reduce the operating range.

IMPORTANT: Before you drill any holes in the wall, please make sure there are not any cables or

pipes that you may accidentally damage.

Remote Control unit - Battery Installation

Remote Control uses 1 x 3volt CR2032 Lithium battery (included), to activate remove the isolation

strip.

To replace slide open the compartment at the back and replace ensuring correct battery polarity.

Wall Socket unit

Wall Socket unit is powered by A/C mains power (100-110volt ~ 60Hz). Plug the Wall Socket unit into

any convenient wall socket. The Wall Socket is now ready to learn the operation code (Please see

Digital Code Set Up).

Installation Guide

To install you will require a drill and cross-headed screwdriver.

Summary of content (4 pages)

PAGE 1
Remote Control Wall Socket Model: WRC-101 The Remote Control Wall Socket consists of two separate units: - 1. 2. Remote Control Unit (Transmitter) Wall Socket Unit (Receiver) These units are completely self-contained and no wiring between them is necessary. Fitting Instructions It is important to install this product in accordance with the fitting instructions below. Failure to do so may render your guarantee void.
PAGE 2
Remote Control Unit Hang using the two holes at the back of Remote Control. Mounting on any metal surfaces will reduce the broadcasting range. Wall Socket Unit Plug the Wall Socket unit into any convenient wall socket. Avoid positioning above heat sources (e.g. radiator) or in damp areas such as a kitchen or bathroom. Connect the lights, TVs or small electrical appliance with the Wall Socket Unit, with wattage not more than 1,100watt or 10amp.
PAGE 3
Important 1. Remote Wall Socket unit is designed for indoor use only. 2. Do not mount the Remote Control onto any metal surface, as this will reduce the operation range. 3. Do not expose either unit directly to rain or immerse in water. 4. Do not mount either unit close to fireplace or expose to high temperature. 5. Dispose of old batteries in accordance with the relevant legislation. 6. There are no user serviceable parts in the unit; do not attempt to repair it. 7.
PAGE 4
FCC Warning Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.