Installation Instructions

User Guidance for the Module Model: 650700080203

FCC ID: Z7A-6507

IC: 4919E-6507

Installation Instructions:

1. Remove the mattress from the cot.

2. Place the cot and Fowler in the full upright position.

3. Remove the cot battery.

CAUTION – Always remove the cot battery before you upgrade the cot to reduce the risk of shock.

4. Using a T25 Torx driver, remove the four pan head thread rolling screws (F) that secure the seat skin (G) to the cot

(Figure 1). Remove and save the seat skin. Save the screws.

Note – Using a T25 Torx driver, torque the pan head thread rolling screws (F) to 4.67 – 6.31 ft-lb.

5. Unplug the solenoid/transducer external cable assembly and HBC strain gauge external cable assembly from the HBC

enclosure assembly.

6. Using a T20 Torx drive, remove the three pan head tapping screws (H) that secure the HBC enclosure assembly (I) to

the birdcage (J) (Figure 2). Save the screws.

7. Using a T25 Torx driver and a 3/8” combination wrench, remove the button head cap screw (K) and Fiberlock nut (L)

that secure the wireless module, if equipped, to the cot (Figure 3). Save the screw and nut.

8. Unhook the wireless module, if equipped, from the frame and drop the wireless module from the bottom of the cot.

Let the wireless module hang from the bottom of the enclosure.

9. Lift the HBC enclosure assembly and wireless module, if equipped, up through the seat section to access the screws

that secure the HBC top cover.

10. Using a T20 Torx drive, remove the seven round washer head tapping screws (M) that secure the top cover (N) to the

HBC enclosure assembly (Figure 4). Remove and save the top cover. Save the screws.

Note – Pay attention to the HBC enclosure assembly and wireless module, if equipped, exit location and connection

point to the board.

Figure 1

Figure 2

Figure 3

Figure 4

PAGE 1
User Guidance for the Module Model: 650700080203 FCC ID: Z7A-6507 IC: 4919E-6507 Installation Instructions: 1. Remove the mattress from the cot. 2. Place the cot and Fowler in the full upright position. 3. Remove the cot battery. CAUTION – Always remove the cot battery before you upgrade the cot to reduce the risk of shock. 4. Using a T25 Torx driver, remove the four pan head thread rolling screws (F) that secure the seat skin (G) to the cot (Figure 1). Remove and save the seat skin. Save the screws.
PAGE 2
11. Insert and connect the supplied cot comm board (650700080203) (O) to the J10 connector on the HBC control board (Figure 6). Note – • Make sure that the grommets for the cot comm board and wireless module are properly positioned between the HBC top cover and enclosure assembly. • See Regulatory notes for information about the supplied cot comm board. 12. Reverse steps 6-10 to reinstall the HBC enclosure assembly.