STRYDE NODE Instructions for Use INITIALISATION DEVICE INSTRUCTIONS FOR USE Document Number: 0000000062 Date: 14th July 2020 Revision: A Copyright © 2020 STRYDE All rights reserved
Initialisation Device Instructions for Use Copyright © 2020 STRYDE. All rights reserved. INTELLECTUAL PROPERTY No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual, or otherwise, without prior written permission of STRYDE. Copyright violators also may be subject to civil penalties.
Initialisation Device Instructions for Use Table of Contents 1. Safety Information ____________________________________________________ 4 2. Certifications _________________________________________________________ 4 3. Introduction __________________________________________________________ 5 4. Product Overview _____________________________________________________ 5 5. Technical specification _________________________________________________ 5 6.
Initialisation Device Instructions for Use 1. Safety Information The following general safety precautions must be observed during all phases of operation of this product.
Initialisation Device Instructions for Use 3. Introduction This manual describes the necessary safety precautions and gives a brief overview of the functionality of the STRYDE Initialisation Device, also referred to as the Initialisation Device. The STRYDE system is a seismic acquisition system for professional use, and the Initialisation Device is used to communicate with the recording sensors and hand-held terminals.
Initialisation Device Instructions for Use 6. Operation Operation of the Initialisation Device shall be carried out by trained personnel familiar with the STRYDE system. During deployment, the Initialisation Device is used to activate the sensor and provide it with all necessary parameters from the hand-held terminal before planting it in the ground. The Initialisation Device is flashing blue and green when it is connected to the hand-held terminal and synchronized to GNSS.
Initialisation Device Instructions for Use 7. Storage and maintenance Long-term storage areas should be clean, cool and ventilated, and large amounts of Initialisation Devices should be kept in storage containers at a safe distance from other structures. When placed in cardboard boxes with plastic packaging material, e.g. for shipping, the Initialisation Devices shall be deactivated to avoid self-heating. Regular maintenance charging of Initialisation Devices in storage is not necessary. 8.
Initialisation Device Instructions for Use 11. Safety Symbols Caution, risk of danger (refer to this manual for specific Warning or Caution information) 12. WARNING A WARNING notice denotes a hazard. It calls attention to an operating procedure, practice, or the like that, if not correctly performed or adhered to, could result in personal injury or death. Do not proceed beyond a WARNING notice until the indicated conditions are fully understood and met. CAUTION A CAUTION notice denotes a hazard.
Initialisation Device Instructions for Use If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures • • • • Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult