Picture similar Digital Active Indoor Antenna SRT ANT 10 ECO User Manual
Table of contents 1 1 2 2 1.0 INTRODUCTION Thank you for purchasing the STRONG SRT ANT 10 ECO DVB-T/T2 Antenna. This antenna has been specially designed to receive digital terrestrial signals from the air. It can be connected to any Digital Terrestrial Receiver (DVB-T/T2), and is designed for INDOOR use only. This DVB-T/T2 antenna is an “Active type” antenna, it has a built-in low noise amplifier that amplifies the received signals for better performance.
.0 SAfETY NOTES before you make any connections: disconnect your equipment from the 230 V main power to avoid electric shocks during installation. Short circuit in the cable MAY permanently damage your Digital Receiver. Never install the antenna outside your house or in humid rooms such as bathrooms. Never use AC adaptors with wrong specifications, this MAY permanently damage your antenna or Digital Receiver. Always check voltages and polarisation of the adaptor before connecting it. 4.
English 1. AC Outlet 2. AC Adaptor (DC 12 V) (Optional) 3. Antenna (Rear view) 4. TV 5. Coaxial cable 6. HDMI cable or SCART cable (optional) 7. Digital Set Top Box 4.1 INSTALLATION OF THE ANTENNA 1. Turn on your TV set and turn on your Digital Terrestrial Receiver. 2. Press the “MENU” button on the remote control of your Digital Terrestrial Receiver. Check in the Set-Up or Installation menu of your receiver if the antenna power is set to “ON”.
In case this option is not supported by your Digital Receiver you need to connect an external power supply to power the antenna. Ask your electronic dealer for an external 230 V AC to DC power adapter that supplies 12 V DC, 250 mA. Note that the + and the – of the power adaptor are located as follows: The connector for the external power supply can be found at the backside of the antenna. NOTE: The antenna will not function properly if the built-in amplifier is not powered.