ASSEMBLY MATERIAL Motor Pod Assembly Air Duct Cover with Electronic Parts Die Cut Base Die Cut Fin Battery with USB Charging Cable x40 x15 Strawberry Connectors Construction Pipes Double Sided Tape Single Sided Tape x4 Plastic Sheets Skirt Template Stickers
Charge the battery before use. A full charge can take up to 3 hours.
SKIRT MAKING & Place the plastic sheet on top of the template. and red line{line 2) on the plastic sheet with a marker. Remove template and sat aside. oles and | & Stick double sided tape just outside the traced red line(Red Line 2). o Peel the protective backing from the double sided tape. Make sure the sheet is flat and carefully pace the second plastic sheet on top. oo Cut along the ester edge of the tape and remove edges.
eo With the center hole still facing down place and cut them out the taped sheets over the template again. o Trace the b from the uncut plastic sheet side. Be careful NOT to cut through both sheets! eo Turn the skirt inside out. With the large center hole facing upwards place single sided tape around the hole's edge and then you have made a skirt! side view double sided tape OR side view om The taped crease will the inside.