Digital Microscope STAD407 Users Manual 2
LIST OF CONTENTS Safety and Maintenance ................................................................ 3 Basic Parameters .............................................................................. 3 What’s in the box .......................................................................... 4 Assembly ............................................................................................. 5 Buttons .................................................................................................
Safety and Maintenance 1. This microscope is safe and low-maintenance, as long as common sense is employed. 2. The assembly includes small parts, particularly the thumbscrews used to hold the main device in place. Do NOT allow unsupervised access by infants or toddlers. 3. The microscope is not intended for field use. It is not waterproof, and should not be exposed to extreme temperatures. Treat as you would any other electronic device, such as laptop or tablet. 4.
What’s in the box (P1,what’s in the box) (P2, Assembly1) (P3, Assembly2) 5
Assembly 1. Screw the optical bracket on to the base (see the left picture above,P2 ). 2. Once you have done so, if the bracket is not aligned over the base, unscrew the locking ring, adjust the bracket’s direction, and then turn the locking ring clockwise until it is tight. (After doing so, it will still be possible to hold the base and turn the bracket if sufficient force is applied, but it will not spin freely.) 3. Loosen the small thumbscrews on the optical bracket. 4.
(P5, remote buttons) (P6 connect ) 7
Quick start Connect To use the microscope stand alone, you need to connect the optical stack to the power supply via the switch cable. See the picture(P6) above. Switch on Then press and hold the Power button (① from the P4 “Buttons”) underneath the display until the display turns on. (It may turn on automatically while you connecting cables at the first time, and it’s totally fine.) *Troubleshooting If the display freezes, locate the “reset ” hole on the back of the monitor.
button to stop playing the current video. Hit the Mode button again to exit playback mode. While reviewing a still image or video, the Menu button can be used to provide additional options. Press the Menu button and hold for a while till options show up.
Netsetting: Use “Up” and “Down” to select among “cross line”、 “line”、 “direction”、 “position”、 “color”and “width”. Use “Left” and “Right” on the remote to change the settings. Without remote can not change any of the settings of netsetting. Cross line means 十 shaped lines that located literally in the middle of the view. when you set the cross line “on”, you will see one horizontal and one vertical showing in the middle of the view.
(P13,Set the color of line 1 to transparent) Date/Time: Press “OK” into Date/time setting. Use “Up” and “Down” to select the correct number for year/month/day. Once you finish setting a number, press “OK” on the monitor to the next number. Or, you can use “Left” and “Right” on the remote to get to the one that you want. Press “MENU” button on the remote to exit date/time setting directly.
Warranty Warranty User’s name: Address: Phone number: Post code: Model name: Purchase date: email: Fault feedback: Date: Fault: Notice: Our warranty doesn’t cover: 1 If users can not provide the purchase proof or the Warranty. 2 If users use it in an improper environment, such as incompatible power supply, high temperature environment etc. 3 If the fault caused by accident, oversight, misoperation or natural disasters etc.