User's Manual

USER MANUAL

Wireless nunchuk is applicable to Wii Remote Control use, the original Wii Remote Control and

Nunchuk were wired connections to connect them, Due to wired connection the gaming distance

was limited, This product is away from way of use the limit as the improvement. the Nunchuk

transmitting end distance may amount to 5-6 meter. Transmitter has searching key, when press the

searching key , the LED will flicker with 2HZ rate, if in 10 seconds it does not connect with the

receiver then it will automatically enter the dormant linking ,the Status Led will go out at the same

time , If the original link connecting the receiver (Registration)is longer than 10 minutes The LED

will flicker showing the 1HZ rate, At this time the receiver and transmitter will go into data

transfer mode. Press Transmitter for 4 seconds, when transmitter connects, it will go into search

mode waiting for the other receivers and the connection (registration),press Comb Key in 10

seconds it will then connect with the original link (registration) receiver . After connected the

Receiver will be open the Wii Nunchuk power , and activate the Wii Nunchuk this will procreant

signal switched to RF signal modules which can be identified by the microprocessor, in the

temporary register, it will also send out completed date when after received a receiver emitted data

conversion orders

Connect the Wii Remote with the receiver and the Wii Remote with the Console, also connect the

receiver with the Wii Nunchuk and installed the battery according to the instructions. At this time

the transmitter will be in sleep mode, press the searching key to wake up transmitter, the

transmitter into the search mode, Status LED flashes to 2 Hz, and then wait for the receiver to

connect with the transmitter, if any receiver is in connection mode, transmitter and the receiver

will be reset identification ID and confirmed to use of other channel connection (registration),

After the wireless Transmitter is connected it will register with the receiver ,and the transmitter

Status LED flashes with the 1Hz. Transmitter and receiver will turn into data transfer mode. With

the transmitter press the searching Key to awaken the transmitter, the transmitter then will go into

the search mode , the transmitter status LED will flash 2 Hz. When the receiver is in the search

mode, the receiver connection led will flash 2 Hz.

PAGE 1
USER MANUAL Wireless nunchuk is applicable to Wii Remote Control use, the original Wii Remote Control and Nunchuk were wired connections to connect them, Due to wired connection the gaming distance was limited, This product is away from way of use the limit as the improvement. the Nunchuk transmitting end distance may amount to 5-6 meter.
PAGE 2
Connection status： 1.Online status of the Transmitter break the connection： When the receiver and the Transmitter has been in connection line status, if connection is cut, the Transmitter will return into the search mode, Connection LED will flash with 1 Hz, Transmitter connected or press comb key again, the receiver and the transmitter can be connected again. 2.