Operating Instructions

Regulatory Compliance and Safety Information for StoneAge Sentinel System Controller (CTRL-100)

USA & Canada Compliance

FCC Part 15, Subpart B / ICES-003 Unintentional Emissions Interference Statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules

and Industry Canada ICES-003. These limits are designed to provide reasonable protection against harmful interference when the

equipment is operated in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC rules and Industry Canada ICES-003. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that

may cause undesired operation.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est

autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter

tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

IMPORTANT! Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s

authority to operate this equipment.

IMPORTANT! Tous les changements ou modifications pas expressément approuvés par la partie responsable de la conformité ont pu

vider l’autorité de l’utilisateur pour actionner cet équipement.

Compliance of this equipment is confirmed by the following label that is placed on the equipment:

FCC Part 15, Subpart C / RSS-210 Intentional Emissions Interference Statement

Compliance of this equipment is confirmed by the following certification numbers that are placed on the equipment:

Notice: The term “FCC ID:” and “IC” before the certification number signifies that FCC and Industry Canada technical specifications

were met.

CONTAINS FCC ID: 2AX9D-SENT001

CONTAINS IC: 26898-SENT001

RF Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the

specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter.

• The equipment should only be used or installed at locations where there is normally at least a 20cm separation between

the antenna and all persons.

• This transmitter must not be co-located or operation in conjunction with any other antenna or transmitter.

• Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s

authority to operate this equipment.

Part Number CTRL-100 Rev A, 03/15/21

866-795-1586 •