User's Manual

Introduction
The STM32MP157C-EV1 and STM32MP157A-EV1 Evaluation boards (STM32MP157x-EV1) are designed as complete
demonstration and development platforms for STMicroelectronics Arm
®
-based dual -A7 32 bits and Cortex
®
-M4 32 bits MPUs in
the STM32MP1 Series. They leverage the capabilities of STM32MP1 Series microprocessors for the user to develop
applications, using STM32 MPU OpenSTLinux Distribution software for the main processor, and STM32CubeMP1 software for
the co-processor. They include an ST-LINK embedded debug tool, LEDs, push-buttons, one joystick, 1-Gbps Ethernet, CAN FD,
one USB OTG Micro-AB connector, four USB Host Type-A connectors, LCD display with touch panel, camera, stereo headset
jack with analog microphone input, four digital microphones, one SPDIF Rx/Tx, Smartcard, microSD
™
card, and eMMC, NOR
and NAND Flash memories.
STM32MP157x-EV1, shown in Figure 1 and Figure 2, is used as the reference design for user application development,
although it is not considered as final application.
To expand the functionality of the STM32MP157C-EV1 and STM32MP157A-EV1 Evaluation boards, two GPIO expansion
connectors are also available for motor control and Raspberry Pi
®
shields.
An ST-LINK/V2-1 is integrated on the board, as embedded in-circuit debugger and programmer for the STM32 MPU and the
USB Virtual COM port bridge.
Figure 1. STM32MP157x-EV1 top view
Figure 2. STM32MP157x-EV1 bottom view
Pictures are not contractual.
Evaluation boards with STM32MP157 MPUs
UM2535
User manual
UM2535 - Rev 2 - August 2019
For further information contact your local STMicroelectronics sales office.
www.st.com