User's Manual

WSR-1 RF Repeater
User Manual
WSR-1 is a RF repeater to extend the operating range of the Wireless
Sentry system.
1. Control Buttons
1.1 POWER button
1.2 PROGRAM button
2. Indicators
2.1 Power on indicator
2.2 Programming Indicator
2.3 Function Indicator
3. Power Connector
3.1 9V AC adapter
4. Installation
4.1 Plug in the AC adapter
4.2 Press the Power button to turn on the power. The red LED should be
ON.
4.3 Program the Repeater ID into the Alarm receiver WR-1 or WR-2. Refer
to the appropriate alarm receiver operation manual.
4.4 Test the completion of installation by pressing the “Check” button
on the Model WT transmitter or activate an alarm from the Pendant
(Model WP-1)or wireless floor mat transmitter(Model WFM-1)
5. Normal Operation
5.1 Mount the WSR-1 Repeater unit at a place some where between the
farthermost Transmitter and the Alarm Receiver
5.2 No attention is required as all alarm signals will be repeated
automatically.
6. Specification
RF frequency: 915 Mhz ISM band transceiver
Power: 9V AC adapter
NOTE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
NTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER AUTHORITY
TO OPERATE THE EQUIPMENT.