User's Manual

Integration instructions for host product manufacturers according to KDB 996369 D03
OEM Manual v01
List of applicable FCC rules
List the FCC rules: 47 CFR Part 15C
Bands of operation: 2400-2483.5 MHz
Specific operational use conditions
N/A: The modular transmitter is intended for use in the STIHL AR batteries.
Limited module procedures
N/A: The module is not a limited module.
Trace antenna designs
The module contains an integrated antenna. It is not allowed to attach a custom antenna to
the product.
RF exposure considerations
All transmitters regulated by FCC must comply with RF exposure requirements. General RF
Exposure Guidance provides guidance in determining whether proposed or existing
transmitting facilities, operations or devices comply with limits for human exposure to Radio
Frequency (RF) fields adopted by the Federal Communications Commission (FCC).
This module must not be co-located or operating in conjunction with any other antenna or
transmitter except in accordance with FCC multi-transmitter guidelines. End users must be
provided with transmitter operating conditions for satisfying RF Exposure compliance.
Antennas
The module contains an integrated antenna. It is not allowed to attach a custom antenna to
the product.
Label and compliance information
If the FCC ID is not visible when the module is installed inside another device, then the
outside of the finished product into which the module is installed must also display a label
referring to the enclosed module. This exterior label can use the following or similar wording:
Contains FCC ID: 2ALP8ARL
Information on test modes and additional testing requirements
It is a module without test modes.
Additional testing, Part 15 Subpart B disclaimer
In addition to marking the product with the appropriate FCC ID, the end-product user manual
may also require specific information based on the digital device classification. Refer to the
FCC Rules, Title 47, Subchapter A, Part 15, Subpart B, Chapter §15.105 for specific wording
of the notices.