Installation Instructions

Page 2
ALL20817
TABLE TOP
*NOTE:PARTSSHOWNONPARTSLISTARENOTTOSCALE
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT
PARTS LIST DESCRIPTION ORDER PART #
HEX BOLT DRIVER
1/4" X 20 MM BOLT
1/4" X 35 MM BOLT
QTY
1
6
4
2
1
1
HW0006
HW0004
A
B
C
D
E
F
G
H
I
LEG CONNECTOR
BRACKET
TABLE LEG
FOOT CAP
FACTORY ASSEMBLY
Ø6.5 X 1.0 MM
WASHER
HW0036
HW0142
6
HW0594
Ø20 X Ø6.5 X 2.0 MM
WASHER
4
Step 1:
Do not attempt
assembly if any parts are missing or damaged.
Remove all protective materials and set parts on a flat,
non-abrasive surface. Identify parts packed in carton
against the parts list. If you are missing any parts or are
unsure how to proceed with assembly, call our Customer
Service Center at 1-800-416-3511.
.
Attach a leg to the leg connector bracket by using
four 1/4"x20 mm bolts and Ø6.5x1.0 washers as
shown in . Guide these bolts through the holes in
the leg connector bracket,
legs. Repeat for the other leg.
mm
Fig 1
Hand tighten only.
into the pre-drilled holes in
the
Step 2:
Fig. 1
FOOT CAP
Fig 2.
With the help of another person, turn the table base
assembly in the upright position. With the help of
another person, carefully place the natural stone table
top onto the table base. After making any necessary
adjustments to the alignment of the table top and the
table base, use a bolts and
washers as shown in Guide the bolt through the
hole in the table leg, into the pre-drilled hole on the
underside of the table top.
Repeat on the other side. (Note: holes do not go
through to the top of the table. Holes shown for
illustration purposes only.)
Step 3:
Fig. .
Do not tighten completely.
1/4"x 5 mm Ø20x2 mm
2
3
Step 4:
ote:
Do not over tighten
After making any necessary adjustments to the
alignment of the table base and table top, use the hex
bolt driver to tighten all bolts. N each bolt must
be tightened a few revolutions at a time. In order to
apply equal pressure to all bolt joints, we recommend
working in a cross corner (X fashion). Repeat until
all bolts are tight. . Over
tightening may strip bolts. Cover all bolts with covers.
,
If you have
any questions, please call our Customer Service
Center at 1-800-416-3511.
At this time your table is now ready for use. If
you use the umbrella, please add the umbrella hole
protective ring to the hole in the tabletop.
Step 5:
IMPORTANT NOTE: Damage to welds or frames resulting
from over tightened bolts or improper assembly is not covered
under our warranty. Please read all instructions carefully
before assembly. If you have any questions regarding your
assembly, call our Customer Service Center at 1-800-416-3511.
FC0030
G0157
B
C
1
TOUCH-UP PAINT
G0003
A
D
F
D
F
G
E
UMBRELLA HOLE
PROTECTIVE RING
FACTORY ASSEMBLY
AT52534
AT52535
AT52536