User’s Manual NGS01 Hardware Manual Rev 1.
NGS01 Hardware User’s Manual Revision record Rev. Date Change Description Editor 1.0 2018-5-05 Initial Version Yong Yang 1.1 2018-8-10 Update block diagram Yong Yang 1.2 2019-4-22 Update LED function Description Yong Yang 1.
NGS01 Hardware User’s Manual Table of Contents NGS01................................................................................................................................ 1 UPDATE MECHANICAL INSTRUCTIONS DESCRIPTION ............................................................... 2 1 INTRODUCTION ................................................................................................................................ 5 1.1 PRODUCTS DESCRIPTION ..............................................
NGS01 Hardware User’s Manual 6.8 SPEAKER ...................................................................................................................... 18 6.9 MICROPHONE............................................................................................................... 18 7 SOFTWARE INSTRUCTIONS ........................................................................................................ 19 8 MECHANICAL INSTRUCTIONS ..........................................................
NGS01 Hardware User’s Manual 1 Introduction 1.1 Products Description Steelcase, Inc. offers both ARM and ATOM based Single Boards Computer (SBC) platforms including Cirrus LogicEP9315,RockChipRK3128, RK3368,RK3288,RK3399, Freescale iMX6, iMX8, TI OMAP35xx CortexA8 series, and Intel Skylake and ApolloLake processor boards. In additional to offering the standard SBCs, we also provide professional customization board design services.
NGS01 Hardware User’s Manual -6- LVTTL Low Voltage TTL 3.3V 3.3 V signal level 5V 5 V signal level USB 5 V tolerant signal PCIe PCI Express signal, not 3.
NGS01 Hardware User’s Manual 2 Foreword 2.1 Copyright Notice While all information contained herein have been carefully checked to assure its accuracy in technical details and printing, Steelcase, Inc. assumes no responsibility resulting from any error or features of this manual, or from improper uses of this manual or the software. Please contact our technical department for relevant operation solutions if there is any problem that cannot be solved according to this manual. Steelcase, Inc.
NGS01 Hardware User’s Manual assumes neither warranty nor legal liability even if the device is still under warranty. 2.6 Safety Instructions Keep and comply with all operation instructions, warnings, and information. Pay attention to warnings on this device. Read the following precautions so as to decrease the danger of injury, electric shock, fire, or any damage to the device. 2.7 Precautions Pay attention to the product labels/safety instructions printed on silk screens.
NGS01 Hardware User’s Manual The device is damaged. The temperature is excessively high. Fault is still not solved after the operation according to the manual.
NGS01 Hardware User’s Manual 3 Over View 3.1 Introduction NGS01 is an Ultra Low power Human Machine Interface Device based on Rockchip RK3288W; 3.2 Specifications Specifications CPU Memory Processor On Board RAM RockChip, RK3288W, ARM Cortex-A17, Quad Core, 1.6GHz LPDDR3 1866MHz, 2GB or 4GB ROM EMMC5.1 WLAN/BT WLAN Module,IEEE802.11a/b/g/n/ac , 2.4G/5G, BT 4.2, internal Antenna Ethernet 1x1000M, with POE,IEEE 802.3at Speaker 1x1W MIC 6x2.
NGS01 Hardware User’s Manual 4 Hardware Instructions 4.
NGS01 Hardware User’s Manual 4.
NGS01 Hardware User’s Manual 4.3 Structure Get the device structure document from Steelcase, Inc. sustain.
NGS01 Hardware User’s Manual 5 Hardware Operation Notes This section provides a guide to set up and use the functions of the Device. For more detailed information on any aspect of thisdevice see Hardware Description. 5.1 Environment The device should be assembled,debugged or used under suggested environment condition to avoid the risk of device damage.
NGS01 Hardware User’s Manual 6 Hardware Description This chapter describes the hardware features, including switches, jumpers, connectors and function. The interface description ought to consult the connector sketch map, and attach to necessary message such as picture. Indicate the feature of functions. 6.1 PowerIn and Ethernet • Power input by POE, POE 802.3atcompliant. • Ethernet:RJ45, 1000Mbps; Position is shown as follow: Figure 5-2: Power input interface 6.
NGS01 Hardware User’s Manual 6.3 LCD LCD:7” 1200x1920400cd/m2(min),Position is shown as follow: 6.4 Touch panel Support 5 points touch;lines:16+24;7”1200x1920;Position is shown as follow: 6.
NGS01 Hardware User’s Manual 6.6 LED LIGHT BOARD LED light board have six RGB lights that are used to decorate only,each light can be controlled by software, Position is shown as follow, : 6.
NGS01 Hardware User’s Manual 6.8 Speaker Internal 8Ω-1w speaker,Position is shown as follow: 6.9 Microphone Internal 38db 6x2.
NGS01 Hardware User’s Manual 7 Software Instructions NGS01 has been pre-loaded software, please refer to Software User’s Manual.
NGS01 Hardware User’s Manual 8 Mechanical Instructions NGS01 have 3 different mount forms. The highest installation height is less than 2 meters.
NGS01 Hardware User’s Manual 3) Paste mounting on the wall -21-
NGS01 Hardware User’s Manual 9 Tips Waste Disposal It is recommended to disassemble the device before abandoning it in conformity with local regulations. Products or product packages with the sign of “explosive” should not be disposed like household waste but delivered to specialized electrical&electronic waste recycling/disposal center. Proper disposal of this sort of waste helps avoiding harm and adverse effect upon surroundings and people’s health.
NGS01 Hardware User’s Manual errors in contents, citations, examples, and source programs. Steelcase, Inc. reserves the right to make necessary changes to this manual without prior notice. No part of this manual may be reprinted or publicly released in forms of photocopy, tape, broadcast, e-document, etc. FCC Warning Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
NGS01 Hardware User’s Manual RF Exposure Statement This equipment must be installed and operated in accordance with provide instructions and the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operation in conjunction with any other antenna or transmitter.
NGS01 Hardware User’s Manual ce matériel doit être installé et exploité conformément à des instructions et l'antenne utilisée pour cet émetteur doit être installé pour fournir une distance d'au moins 20 cm de toutes les personnes et ne doit pas être installé ou opération conjointement avec toute autre antenne ou transmitter.les utilisateurs finals et les installateurs doivent fournir des instructions d'installation et d'antennes - conditions relatives à l'exposition aux champs rf de conformité.