Seat belt detection kit (To be pasted on the inside of the driver’s seat belt)
Stick on the inside of the driver's driver’s seat belt slot 7 8 Buckle the driver’s seat belt 9 The display “Bi” once to indicate the seat belt is buckled 3 Stick on the inside of the driver's seat belt slot 4 5 Buckle the driver’s seat belt 6 The display “Bi” once to indicate the seat belt is buckled
7 8 Display will “Bi” twice immediately to enter working mode The display will flashing in turn with red & green lights until baby left the car seat or the display is turn off.
5. Baby is remained on the car seat after unbuckle the driver’s seat belt: 1 Unbuckle the driver’s seat belt 4 The display will flashing in turn with red & green lights until baby left the car seat or the display is turn off.
7.
If sensor pad in low battery status ACC ON, and baby sit on the car seat, when the system detectsthe sensor pad is in low battery status, the display will warning and yellow light flashing for 3 times, then the light will return to green, and the system will back to the working mode.
The display will “Bi” twice with green light flashing, then enter the next programing. 1 Buckle the driver’s seat belt, then unbuckle it The display will "Bi" once with yellow light flashing, then enter the next programing After all parts are programmed, hold “SET” button, Then the display will warning to save and exit the programming mode. Note: 1.Only 2 sensor pads and 1 seat belt detection kit can be up to programmed. 2.
DC 3V (2V~3.6V >20N Seat belt detection kit DC 3V (2V~3.6V 3. Sensor belt detection kit not work The sensor belt detection kit battery is low, please change to new sensor belt detection kit. The display and sensor belt detection kit are not programmed. The seat belt buckles with inner wall thickness 7mm will affect the use of this part.
4. The vehiclewith the CIG lighter has the electricity after flame out, must be equipped with seat belt detection kit. 5. 1. This system is designed for reminding drivers to take their baby with them whenever they leave the car. 2. STEELMATE does not take any responsibility for any accident happen because of negligence. 3. This system is designed for a reminder purpose only, not a lifesaver. 4. Before using this system, please read the manual carefully.