Quick Start Guide

FCC Part 15.19
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
FCC Part 15.21
Any changes or modifications (including the antennas) to this device that are
not expressly approved by the manufacturer may void the user's authority to
operate the equipment.
Note : This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications,
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RSS-Gen 8.4
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux
CNR d’Innovation, Sciences et Développement économique Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
FCC and ISED RF Radiation Exposure Statement:
This equipment complies with FCC and ISED RF Radiation exposure limits set
forth for an uncontrolled environment. This device and its antenna must not
be co-located or operating in conjunction with any other antenna or
transmitter. This equipment should be installed and operated with a minimum
distance of 20 cm between the radiator and your body
FCC/ ISED ID
- FCC ID: 2AY4GSTC-IP11
- ISED ID: 27062-STCIP11
Venda Stores Inc
6303 Blue Lagoon Drive Suite 400 Miami Florida 33126
Phone : [phone]
English:
German:
French:
Spanish:
Italian:
Portuguese:
English:
German:
French:
Spanish:
Italian:
Portuguese
01 P
11 P
21 P
31 P
41 P
51 P
This quick start guide contains important
instructions for using this STATIC product.
Please only use this product after fully
understanding the contents of
this quick start guide.
Images may differ in appearance from
the actual product. Contents are subject
to change without prior notice.
03. 04.01. 02.
CASE BATTERY
Product components
Please check the components before use.
Case
Battery
Quick start guide
1EA
1EA
1EA
How to use the power bank
Smartphone case and power bank combination
Slide the phone into the case from the top down.
Move around slightly to make sure it fits properly.
There is a built-in iron plate inside the case.
Be careful not to lose it.
05. 06. 09. 10.
After placing the power bank on the back of the smartphone
case and pressing the power button, the LEDs light up and
wireless charging begins.
Do not charge the smartphone without the smartphone case.
Ensure there are no foreign metal objects (cards, magnets etc.)
between the power bank and the smartphone.
Smartphone wireless charging method
How to use the power bank How to use the power bank
Connect the Lightning cable to the power bank to charge.
It is recommended to use a MFI certified Lightning cable,
and an adapter that supports 7.5W or higher power.
* Do not charge more than 24 hours.
Charging the power bank
* Up to 10W (5V/2A) can be charged
using the fast charging adapter.
07. 08.
Simultaneous charging of the power bank
and the smartphone
Simultaneous charging is possible by connecting the Lightning cable
to the power bank after combining the smartphone with the
power bank.
Normal method
Other method
Simultaneous charging is possible by combining the smartphone
while charging the power bank and pressing the power button
of the power bank once.
( It is not necessary to press the power button if the smartphone is
connected to the power bank within 15 seconds.)
How to use the power bank
Normal charging mode
Simultaneous charging mode
You can check the remaining battery level using the LEDs
on the front of the product.
Simultaneous charging
The LEDs blink sequentially from bottom to top, and then
the LEDs flash according to the remaining battery level.
Low battery indication (under 15%) - 1 LED blinks
LED indicator lights
The LEDs only blink for the first 15 seconds of charging
Charging status
When charging, the LEDs blink as below.
You can charge the power bank and the smartphone
at the same time.
iPhone X/XS/11Pro
Case_ 53g/76x147x11 (mm)
Battery_150g/72x108x17 (mm)
1INP10/56/66
iPhone XR/11
Case_ 55g/79x155x12 (mm)
Battery_152g/76x111x17 (mm)
1INP10/56/66
iPhone 12/12Pro
Case_ 48g/76x151x11 (mm)
Battery_130g/76x110x12 (mm)
1INP65/62/84
Precautions
1. Charge the product fully before the first use.
2. Avoid using in-car chargers to charge the product, as their voltage
and current may vary.
3. Do not disassemble the product, or use the product for any purpose
other than that for which it was designed.
4. Do not charge the product in an enclosed space such as a car, in
places that can become hot easily, or near a heat source.
5. Store and use at temperatures between 0 and 40°C.
6. Do not charge on heat-insulating surfaces such as carpets, blankets,
sofas, beds, etc.
7. Do not expose the product to shocks, moisture, fire, sensitive skin, etc.
8. Do not allow the product to come into contact with water.
9. Only charge the product using a charger of appropriate voltage.
10. Keep the product out of reach of children.
11. Do not use the product in an environment where it may be damaged
by pets.
12. If the product bloats due to battery malfunction, discontinue use of
the product immediately.
13. When storing the product for an extended time period, charge the
battery to 50% capacity every month.
14. This product is not waterproof, and no compensation shall be given
in case of water damage.
15. Ensure that no conductive foreign materials enter the charger port.
16. Keep the product away from magnetic items such as credit cards,
phone cards, bank books, traffic cards, etc, as the product may cause
them damage.
17. Do not place in close proximity to computer monitors, televisions, or
other similar electronic products.
18. When charging wirelessly, the product’s temperature may increase
slightly, so the smartphone may become hot; especially when using
apps or games that use a significant amount of power.
19. Do not dispose of drained batteries irresponsibly.
20. When disposing of a used battery, do not place it in an incinerator or
fire. Excessive heat may cause an explosion or fire.
21. When disposing of a secondary cell or battery, separate cells with
different electrochemical systems and dispose of them separately.
22. To prevent battery overheat, dispose of used batteries in a discharged
state.
23. We recommend that the smartphone battery is charged wirelessly
when attached to a STATIC smartphone case.
24. The manufacturer accepts no responsibility for damage to the
product due to user negligence.
25. The warranty period for the product is 1 year from date of purchase.
26. Requires 7.5W or above Wall Charger.
Product Specification
STATIC Power bank
PC/TPU
STATIC
KOREA
STATIC
Weak field strength
radio equipment
Secondary Li-Polymer
3.7V 5000mAh
5.0V 2.0A / 9.0V 1.11A
110.01khz ~ 146khz
(4.62 dBuA/m at 10m, 5W)
110.01khz ~ 133khz
(0.94 dBuA/m at 10m, 10W)
Product name
Materials
Manufacturer
Country of origin
Trade name or applicant
Equipment name
Battery rated capacity
USB input / Wireless output
Wireless charging frequency
(Output power)
Weight / Size / Battery type
0~33%
16~33% 34~66% 67~100%
0~15%
34~66% 69~99% 100%
0~33% 34~66% 67~100%
61. 62.