User's Manual

Product View
Quick Installation Guide
Day&Night IP Camera
Connect IP Cam to Internet
1. Connect the power adapter.
2. Connect the Ethernet cable to the NAT/Router.
3.The IP camera will get IP address from the NAT/Router (with DHCP
enabled) automatically and connect to internet. Check if the red
LED of IP camera is always on. If it’s blinking, please check step 1
and step 2 again.
Install CamView Software
Please download the latest CamView software with the following information :
Website: http://www.starvedia.com/download.html
Username: viewer
Password: camview
Step 1.
Step 2.
Installation Guide
IP Cam
NAT/Router
Ethernet Cable
Power Adapter
Quick Installation Guide
Day&Night IP Camera
IR LED
Light Detector
Microphone
Night Time Lens
!"!#$%&'()
Micro-SD Card Slot
*+,-(./0$12-3$4)3+,25()$670
7#8!-)!#$4)3+,25()$670
/#2#&"$4)3+,25()$670
9:/$%&'()
Day Time Lens
[ Front View ]
[ Back View ]
[ Right Side View ]
Internal Speaker
Power Jack
Ethernet Jack
ID
Password
IP Cam QIG
Anchors
and Screws
ID/Password Card
Pow e r A d apt e r
Eth e r ne t Ca b l e
LAN
WAN
Package Contents
Qu
Internet
www.starvedia.com/download.html