User's Manual

ManualsBrandsStarnex ManualsElectronicsWearable digital communicator

ROLLTS DOMINO S1 User guide

Checklist before using the device

Federal Communications Commission statement

NOTE : Change or modification not expressly approved by the party responsible for Compliance could

void the user’s authority to operate the equipment.

NOTE : This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures.

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

- Consult the dealer or an experienced radio, TV technician for help.

- Only shielded interface cable should be used.

Finally, any changes or modifications to the equipment by the user not expressly approved by the

grantee or manufacturer could void the user’s authority to operate such equipment,

NOTE : Exposure to Radio Frequency Radiation. Antenna shall be mounted in such a manner to

minimize the potential for human contact during normal operation.

The antenna should not be contacted during operation to avoid the possibility of exceeding the FCC

radio frequency exposure limit.

NOTE : This device complies with part 15 of the FCC Rules.

NOTE : Operation is subject to the following two Conditions :

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired

operation

NOTE : This appliance and its antenna must not be co-located or operated in conjunction with any

other antenna or transmitter.

Summary of content (10 pages)

PAGE 1
ROLLTS DOMINO S1 User guide Checklist before using the device Federal Communications Commission statement NOTE : Change or modification not expressly approved by the party responsible for Compliance could void the user’s authority to operate the equipment. NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 2
Industry Canada statement This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two Conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.” Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
PAGE 3
Component names 1.
PAGE 4
2. LCD Use 1. Charge Type LED LCD When charging is in Red Each one of three white progress, When charging is complete, cells pops up over time. Green Full with three white cells. 2.
PAGE 5
3.
PAGE 6
4. Using the speaker system 5. Volume up/down The volume goes up by one notch as you push the The volume goes down by one notch as you push the ‘UP’ button one time. ‘DOWN’ button one time. 6. Button lock + more than 2 seconds. 7. Communication (default setup) ① Talk to the device while pushing the PTT button to send your voice to a person on the other device. Stop pushing the button when you stop talking. ② The earset or the speaker enable you to hear what the other person says if there is a response.
PAGE 7
8. Vibration call more than 2 seconds. 9. Emergency call Push PTT button repeatedly at a fast speed (3 times within one second). Select how to wear device 1. Clip  How to put the clip onto the device  How to detach it 2.
PAGE 8
Checklist for setting up the menu 1. Enter the menu Enter the menu by pushing the ‘M’ button for more than 2 seconds. 2. Move to a menu item In the menu, move to an item from another item by pushing the ‘M’ or ‘C’ buttons. 3. Select an item An item in the menu can be selected by pushing the PTT button (front). 4. Adjust and Move to a value Adjust it by pushing the ‘UP’ or ‘DOWN’ buttons. Move to a value from another value by pushing the ‘M’ or ‘C’ buttons. 5.
PAGE 9
is allowed to talk. Full-duplex -> Available for simultaneous ‘transmit’ & ‘receive’ functions. Able to listen while talking. Two radios in the group are allowed to talk at the same time. Tri full-duplex -> Available for three-way simultaneous ‘transmit’ & ‘receive’ functions. Three radios in the group are allowed to talk at the same time. Hi-fi half -> Using the same communication method as the half-duplex mode, this mode allows for high-quality voice communications.
PAGE 10
 Weight: 42 g (1.48 oz)  Multi-party call: Tri full-duplex  Range (Line of Sight): Up to 3 km (1.86 miles)  Stand-by: One month  Usable time: 7 days (1day (24h) = 8h talk time + 16h stand-by) (Talk time: 5-5-90 duty cycle) (Usable time can be longer by setting RF POWER)  Encryption: AES-256  Frequency hopping: 902-928 MHz ISM band, 50 channels, 1,000 groups/channel  The maximum range is 3 km with a clear line of sight.