REMOTE CONTROL O P E R AT I O N S M A N U A L
BASIC MODEL ADVANCED MODEL 1 1 2 2 7 3 3 8 6 4 4 5 TruLink® Remote allows for easy and discreet adjustments to your hearing instruments. With its long-life battery, your TruLink Remote is always ready to work with your hearing instruments. 2 5 1. Ear Selection Switch Advanced Model Only 2. Volume Up 6. Mute/Unmute 3. Volume Down 7. Memory Change 4. Home 8. Favorite 5.
Pairing Process For TruLink Remote to interact with your hearing instrument(s), you must first pair the Remote with each hearing instrument. You only need to pair TruLink Remote with a hearing instrument one time, as they should automatically recognize each other when both are powered on and they are within wireless operating range. You can pair TruLink Remote with a monaural hearing instrument, or binaural hearing instruments.
Left Both Right Ear Selection Switch The Ear Selection Switch controls whether adjustments are made to a single hearing instrument or both hearing instruments. Binaural Hearing Instruments: To adjust both hearing instruments at the same time, the Ear Selection Switch should be positioned in the center. To adjust a single hearing instrument, place the Ear Selection Switch to the Left or Right position indicating the hearing instrument to be changed.
ADVANCED MODEL ONLY ADVANCED MODEL ONLY Mute/Unmute Favorite To temporarily turn off all sounds presented in the hearing instruments, press the Mute/Unmute button. To unmute the hearing instruments, press the button again. Your hearing instruments have the following Favorite button configuration: NOTE: When the hearing instruments are muted, selecting any button will unmute the hearing instruments as well as perform the function of the button selected.
Lanyard (optional) Regulatory Notices 1. Insert thin cord into end of TruLink Remote housing until loop is exposed. Required Information 2. Thread lanyard through loop and pull lanyard. Lanyards can be obtained from your hearing professional (ask for part #90974-000). Waste from electronic equipment must be handled according to local regulations.
TruLink Remote is classified as a Type B applied part under the IEC 60601-1 medical instrument standard. TruLink Remote is designed to comply with the most stringent Standards of International Electromagnetic Compatibility. However, it is still possible that you may experience interference caused by power line disturbances, airport metal detectors, electromagnetic fields from other medical devices, radio signals and electrostatic discharges.
WIRELESS TECHNICAL DESCRIPTION The TruLink Remote operates in the 2.4-2.4835 GHz band with a maximum effected radiated power of 3 dBm with transmission modulation type of 1M06F1W. The receiver section of the radio has a bandwidth of 2 MHz. The TruLink Remote has been tested to, and has passed, the following emissions and immunity tests: • IEC 60601-1-2 radiated immunity requirements for a Group 1 Class B device as stated in CISPR 11. • RF radiated immunity at a field level of 10 V/m between 80 MHz and 2.
Notes The TruLink Remote operates in the 2.4 - 2.4835 GHz band with a maximum effective radiated power of 3 dBm. Hereby, Paradigm declares that the TruLink Remote is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. A copy of the Declaration of Conformity can be obtained from the addresses below. Paradigm, Inc. 6600 Washington Ave. South Eden Prairie, MN 55344 USA Paradigm, Inc. European Headquarters Wm. F.
Notes 18 Notes 19
© 2017 Paradigm, Inc. All Rights Reserved.