User's Manual
Transmit Module User’s Manual
-DRAFT-
The WTC TX (Wireless Tool Control Transmit) module
is a 433 MHz transmitter for sending DEWALT WTC
status messages. These messages are commonly used
to signal if a tool is operating which can be used to turn
on and off a remote vacuum or dust extractor
equipped with a corresponding receiver. The WTC TX
module is based on the Microchip MICRF112 UHF
transmitter and the ATTINY416 microcontroller. The
WTC TX module is classified by the FCC as a Single-
modular transmitter which is a complete RF
transmission sub-assembly designed to be
incorporated into another device.
Table of Contents
1. General description
1.1 Simplified block diagram
2. Electrical characteristics
2.1 Circuit activation
3. Compliance information