User's Manual

Purpose

This document describes the installation process of the TLCKMAJD Module in

Stanley Black & Decker battery packs.

NOTICE: Installation of this module may only be made by qualified

Stanley Black & Decker Installer. This is not a field upgrade, and

must be done at the Stanley Black & Decker factory.

The user manual for the end product must include the following

information in a prominent location (including English and French

for Canada):

To comply with FCC and Industry Canada RF radiation exposure limits for

general population, the antenna used for this device must not be co-located or

operating in conjunction with any other antenna or transmitter.

Pour se conformer à la FCC et d'Industrie Canada limites d'exposition aux

rayonnements RF pour la population générale, l'antenne utilisée pour cet appareil ne

doit pas être co- localisées ou opérant en conjonction avec une autre antenne ou un

autre émetteur.

FCC Notice

FCC ID: YJ7TLCKMAJD

Compliance Statement (Part 15.19)

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may

cause undesired operation.

Warning (Part 15.21)

Changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

FCC Interference Statement (Part 15.105 (b))

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

PAGE 1
Purpose This document describes the installation process of the TLCKMAJD Module in Stanley Black & Decker battery packs. NOTICE: Installation of this module may only be made by qualified Stanley Black & Decker Installer. This is not a field upgrade, and must be done at the Stanley Black & Decker factory.
PAGE 2
- Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help.
PAGE 3
5) Solder B+ and B- leads to cell terminal tabs and the four cell tap locations to the module PCA. 6) Inspect all solder locations. 7) Place mica insulator over B- lead on the module PCA.