User's Manual

ManualsBrandsStanley Black & Decker ManualsElectronicsBluetooth Tool Module

Purpose

This document describes the installation process of the DeWalt Bluetooth Drill

Module, N457147J.

Notice: Installation of this module may only be performed by a qualified Stanley

Black & Decker Installer. Installation is not a field upgrade and must be done at

the manufacturing facility of the end-product tool.

To comply with the FCC and Industry Canada RF exposure limits for general

population/uncontrolled exposure, the antenna used in the module must be

installed as to provide a separation distance of at least 5 mm from all persons and

must not be operating in conjunction with any other antenna or transmitter.

If the module is used in a multi-transmitter or simultaneous transmission host

then the module must be evaluated and approved to one of the host platform

exposure conditions (Mobile, Portable, or Mixed Mobile and Portable exposures).

Pour se conformer aux limites d’exposition aux RF de la FCC et d’Industrie Canada

pour la population générale/exposition non contrôlée, l’antenne utilisé pour cet

émetteur doit être installé pour fournir une distance de séparation d’au moins 5

mm de toutes les personnes et opérant en conjunction avec une autre antenne

ou émetteur.

Si le module est utilisé dans un environment multi-émetteur ou hôte de la

transmission simultanée alors le module doit être evaluée et a approuvé l’une

quelconque des conditions d’exposition de la plate-forme d’accueil. (Exposition

mobile, l’exposition portable, ou l’exposition mobile et portable mixte).

Summary of content (5 pages)

PAGE 1
Purpose This document describes the installation process of the DeWalt Bluetooth Drill Module, N457147J. Notice: Installation of this module may only be performed by a qualified Stanley Black & Decker Installer. Installation is not a field upgrade and must be done at the manufacturing facility of the end-product tool.
PAGE 2
End-Product Marking and Instruction Manual The DeWalt Bluetooth Drill Module is labeled with its own FCC ID and IC number. If these numbers are not visible upon installation in the end-product the outside of the end-product must display a reference to the Module numbers in a visible area.
PAGE 3
FCC Notice FCC ID: YJ7-N457147J Compliance Statement (Part 15.19) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. FCC Warning (Part 15.21) Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
PAGE 4
PAGE 5
Industry Canada Notice IC: 9082A-N457147J Section 8.3 of RSS-GEN Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. Section 8.