Instructions / Assembly

Table Of Contents

Assembly Instructions

Model No. 11010933BRN

TOOLS REQUIRED

*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE

Page 1

CAUTION:

Ladder

Safety

Glasse

Electricall

Tape

Phillips

Screwdrive

Flat Blade

Screwdrive

Pliers

Wire

Strippers

Fixture

Mounting

Screws

Wire

Nuts

Inspect the wire insulation for

any cuts, abrasions, or

exposed copper that may

have resulted during

shipping. If there is a defect in

the wire, do not attempt

installation.

Before starting installation of

this fixture or removal of a

previous fixture, disconnect

the power by turning off the

circuit breaker or by removing

the fuse at the fuse box.

Glass

Shades

Mounting

Unit

PAGE 1
Assembly Instructions Model No. 11010933BRN CAUTION: ! Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation. Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
PAGE 2
Assembly Instructions Model No. 11010933BRN STEP 1 Use the mounting screws to attach the mounting unit to the junction box. STEP 2 Make the electrical connection from the junction box to the fixture. Connect the ground wire to the mounting unit using the pre-installed green ground screw. Then, connect the positive, negative, and ground wires with the supplied wire nuts. Secure with electrical tape. STEP 3 STEP 4 Place the canopy over the Mounting Unit and secure the fixture with the Cap Nuts.