User's Manual

WARNING

Read and review all instructions, illustrations and warnings if included or follow manufacturer

recommended service and replacement procedures before installing. Professional Installation

Only. Improper installation may result in the failure of the motor vehicle Tire Pressure

Monitoring System (“TPMS”) Sensor to operate properly.

Removal

1) The tire and wheel assembly removal must be followed as outlined in the vehicle

manufacturer’s Service Manual.

Installation

1) Inspect the sensor band and cradle and replace as needed.

2) Position the sensor into the cradle by inserting hinge end of the sensor into the hook end of

the cradle and pushing the opposite end of the sensor down onto the cradle. Ensure sensor is

fully seated into cradle ( a “click” noise will be heard).

3) Insert a new locking clip into the sensor.

4) Position Sensor 180 degrees from valve stem and tighten band.

5) The tire and wheel assembly installation must be followed as outlined in the vehicle

manufacturer’s Service Manual.

FCC and IC Notice

This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

Warning: Any changes or modifications in construction of this device which are not expressly

approved by the party responsible for compliance could void the user’s authority to operate the

equipment.

1- Band

2- Sensor

3- Clip

4- Cradle

BG1-001