USER GUIDE MULTI-CHANNEL STEREO MIXER S MIX 4M4S S MIX 4M4S D
FEATURES 4 mono input channels and 4 stereo input channels. 3-band frequency EQ for each input channel. Low-noise mic pre-amp on microphone inputs. Optional low cut filter to reduce low frequency interference for mono input channels. 10dB attenuator switch on stereo channel. Individual stereo play input and record output channel. Monitor and headphones outputs. Peak indicator on each mono channel. +48V phantom power for condenser microphones. Built-in 16-preset DSP effect processor.
CONTROL PANEL MONO CHANNEL SECTION 1. MIC This is an XLR type connector for microphones. The input level ranges from -60 to -20dB. This connector can provide +48V phantom power for condenser microphones when the phantom power is switched on. 2. LINE This is a balanced 1/4” phone jack for linking a line level source The input level ranges from -40 to 0dB. 3. GAIN Use this knob to adjust the level of the input signal to the optimal level.
STEREO CHANNEL SECTION 3A 1. L/MONO - R These are two unbalanced 2-pole phone jacks for stereo line input. The input level range is -10dB. If the source signal is mono please use the left channel. 2. -10dB Press this switch to attenuate the line input signal -10dB to fit a high level signal source. 3A. AUX (4M4S only) Use this knob to control the signal level sent from each channel to the AUX bus. It is set before the channel fader, so it is not dependent on the fader position. 3B.
MASTER CONTROL SECTION 1. AUX SEND This jack socket sends the signals to an auxiliary source. 1. EFF SEND / FT SW (4M4S D MODEL ONLY) This is a 1/4” jack input for sending EFF output signals. It also can be linked to a foot switch to control the built-in effects processor. 2. PHONES This jack socket sends the signals from main output or tape player to the headphones. 3. CTRL RM These two jack sockets send stereo signals from the master output or an external player to the control room speakers. 4.
MASTER CONTROL SECTION S MIX 4M4S S MIX 4M4S D 14. AUX TO CTRL RM Press down this button to feed the AUX signal to the control room and headphones; and the AUX signal is not controlled by 13. 15. PHONES / CTRL RM This knob controls the signal level to the control room and headphones. 16. EFF SELECT This knob is used for selecting one from 16 kinds of effects (refer to the effects table beside the selector). 17.
SPECIFICATIONS ing 1.47Kg SMIX 4M4S D - 1.
IMPORTANT SAFETY INSTRUCTIONS READ AND KEEP THESE INSTRUCTIONS. HEED ALL WARNINGS. • If, after you have followed the instructions outlined above, this device fails to function, please contact your dealer. Under no circumstances should this device be opened. Leave all servicing to qualified personnel. • Electrical appliances must never be used in conditions of high humidity or heat. To prevent any risk of fire or electric shock, never spill or splash liquids on this device.