Installation Guide

2700 Camino de Verdad
Weslaco, TX 78596
1 [phone]
VANITY INSTRUCTIONS
LIMITED LIFETIME WARRANTY
The product has been manufactured by WoodCrafters Home Products, LLC and is warranted under normal use and service, to be free from defects in material and workmanship
for the life of the product from the date purchased. During this warranty period, WoodCrafters Home Products, LLC will repair or replace at WoodCrafters Home Products, LLC
sole option, free of charge, any defective part or parts returned with shipping charges prepaid to the distribution center listed below. Please include the original receipt with date
of purchase and the nature of the problem. Merchandise not returned prepaid will be refused. Our warranty does not cover damage or failure caused by abuse, misuse, abnormal
usage, faulty installation, improper maintenance or any repair other than those by WoodCrafters Home Products, LLC There are no obligations or liabilities on the part of
WoodCrafters Home Products, LLC for consequential damage arising out of or in connection with the use or performance of the product or any indirect damages included, but not
limited to labor charges for installation or removal. This warranty gives you specific legal rights, and you may also have other rights that may vary from state to state. Further
information regarding this warranty may be obtained without charge by contacting WoodCrafters Home Products, LLC Customer Service. If any Parts are missing or damaged,
please call WoodCrafters Home Products, LLC Customer Service at [phone], between 8:00 AM and 5:00 PM C.S.
WoodCrafters Home Products, LLC
2700 Camino de Verdad, Weslaco, TX 78596-1266
HINGE ADJUSTMENT
The door alignment was set in the factory and should not
require adjustment unless the cabinet was racked or twisted
during installation. If adjustment is needed, follow the
instructions provided in the adjacent chart.
CARE & MAINTENANCE:
Cleaning Instructions: To clean surface of doors or cabinet,
use non-abrasive cleansers only.
HINGE / DOOR ADJUSTMENT
CABINET FRONT VIEW CABINET SIDE VIEW
B
C
CABINET FRONT VIEW
Drawer Box
Decorative Hardware
Alignment Screws
Drawer Front
Alignment System
Screws
A
Used to adjust
door height
A
Used to adjust
gaps between doors
B
Used to adjust between
door and cabinet
C
INSTALLATION INSTRUCTIONS
BATHROOM CABINETS
Top Back Rail
DRAWER FRONT ADJUSTMENT
1. Fasten the Vanity Cabinet to the wall with screws (not provided) into wall studs through the
back top rail, or use toggle bolts if necessary.
2. Knobs/Pulls: Knobs/Pulls are attached to the inside of the vanity. Reattach so the
pulls/knobs are visible from the outside of the doors. Use the adjustment diagram below to
align your cabinet fronts.
NOTE: Decorative hardware and alignment system screws are located inside the drawer box.
1. Remove decorative hardware from the drawer front.
2. Hold drawer front in place and slightly loosen both alignment screws.
3. Move the drawer front left, right, up or down to desired position for alignment.
4. While holding the drawer front in place, tighten the alignment screws securely.
5. Install the decorative hardware to the outside of the drawer front.
Revised January 2010
550297