User's Manual

Q Buon

Cellular Status

GPS Status

Baery Statuss

Power Meter

Indicator

Charging Port

Heart Rate

Indicator

Other Ant+

Indicator

Qollector

To pair the Qollector with a sensor, press and release

the and hold the Qollector near the sensor. The

corresponding white icon will light up when the

sensor is paired. Up to 7 sensors can be paired with

the Qollector.

Press the to check the Cellular Status, Baery

Status, and GPS Status. The will blink oen when

on and connected.

Double tap the front surface of the device to drop a

pin and record a speciﬁc point in your activity. You

can view the pin in your autosync destinations.

The Qollector will collect and store data when it is ﬁrst turned on, but

you will need to create an account on QuarqNet.com to view, download

and sync your data.

To Start or Finish an Activity: Power the Qollector on and allow the

cellular towers and GPS to sync before starting your activity. When you

have ﬁnished your activity, power the Qollector oﬀ. Your activity will

automatically be named and synced up with your autosync

destinations.

Using the Qollector

For complete instructions, visit our website at

quarq.com/qollector.

Press and hold the for three seconds to power

the Qollector on or oﬀ. When powering on, the status

icons will light up green and the Qollector will beep

and vibrate. When powering oﬀ, the icons will ﬂash

red and the Qollector will beep and vibrate.

Front Surfaces

Commands

Press

Press -

Sec

Double Tap

PAGE 1
Qollector Commands Charging Port Power Meter Indicator Q Button Heart Rate Indicator Cellular Status Other Ant+ Indicator GPS Status Battery Statuss Press - 3 Sec Press Double Tap Press and hold the for three seconds to power the Qollector on or off. When powering on, the status icons will light up green and the Qollector will beep and vibrate. When powering off, the icons will flash red and the Qollector will beep and vibrate.
PAGE 2
Color Definitions DRAFT Solid Light: Connected to a tower - Data synced Two second fade: Connected to a tower - Data unsynced One second fade: No tower found Solid Light: GPS locked Two second fade: GPS searching One second fade: GPS disabled Solid Light: Battery Status Good: 100% - 35% Two second fade: Battery Status Low: 35% - 10% One second fade: Battery Status Critical: 10% or less Power Meter Paired Heart Rate Monitor Paired Ant+ Device Paired For complete instructions, visit our website at quarq.