Installation Guide

ManualsBrandsSQUARE FOOT ManualsBuilding materials32 in. x 22 in. x 32 in. Plastic Concrete Footing Form

SQUARE FOOT®

CSI SPECIFICATIONS

Our unique, patented SQUARE FOOT

design provides increased stability and

bearing capacity, provides superior resistance to uplift; facilitates rebar; and,

levels easier than any other footing form on the market and meets or exceeds

all building code requirements. Square footings are the standard of the con-

struction industry and have stood the test of time for thousands of years.

IF YOU CAN BUILD IT,

WE CAN HOLD IT!

Sound Footings LLC : 37 Talcott Road, Williston , VT 05495 Tel: 802-764-2323 Fax: 802-764-5605 www.sqfoot.com

SMART

SQUARE

Summary of content (5 pages)

PAGE 1
SQUARE FOOT® CSI SPECIFICATIONS BE SQUARE BE SMART IF YOU CAN BUILD IT, WE CAN HOLD IT! Our unique, patented SQUARE FOOT ® design provides increased stability and bearing capacity, provides superior resistance to uplift; facilitates rebar; and, levels easier than any other footing form on the market and meets or exceeds all building code requirements. Square footings are the standard of the construction industry and have stood the test of time for thousands of years.
PAGE 2
Sound Footings, LLC May 2004 37 Talcott Road PO Box 818 Williston, Vermont 05495 Phone (802) 764-2323 Fax (802) 764-5605 Website www.sqfoot.com Product Guide Speciﬁcation Speciﬁer Notes: This product guide speciﬁcation is written according to the Construction Speciﬁcations Institute (CSI) 3-Part Format, including MasterFormat, SectionFormat, and PageFormat, contained in the CSI Manual of Practice.
PAGE 3
1.3 REFERENCES Speciﬁer Notes: List standards referenced in this section, complete with designations and titles. This article does not require compliance with standards, but is merely a listing of those used. A. ACI 301 - Standard Speciﬁcation for Structural Concrete. B. ICBO Evaluation Service ES Report ER-6073. 1.4 SYSTEM DESCRIPTION A.
PAGE 4
1. 2. Description: Engineered, prefabricated, permanent, footing forms for concrete. Material: Polypropylene. 3. Shape: Square base that tapers up to conical shape to allow for round column forms to be attached to top of footing forms. 4. Holes: Concrete placement air vent holes and reinforcement bar tie holes. 5. Bottom Flange: Anchor footing forms in position. B. 1. 2. Identiﬁcation: Model number engraved on base. Labels attached indicating ICBO evaluation service report number ICBO ER-6073.
PAGE 5
A. Examine area to receive footing forms. Notify Architect if area is not acceptable. Do not begin installation until unacceptable conditions have been corrected. 3.2 INSTALLATION A. Install footing forms in accordance with manufacturer’s instructions. B. Cut and remove rings on top ﬂange of footing forms that are smaller than largest diameter ring that ﬁts inside round column forms. C. Install round column forms over top ﬂange of footing forms. D.