Manualshelf

User Guide

ManualsBrandsSpy Tec ManualsCamera & PhotoSpy Tec Mobius 1080p 60FPS HD Lightweight Action Camera with Loop Recording
123456789
User Guide for the Mobius Mini ActionCam
Description
The above picture shows the arrangement of the user operating features.
►This manual does not cover replacing the internal battery or lens.
►This manual assumes the camera is loaded with the latest firmware available at the time of
writing. Functionality may vary with earlier or later firmware versions.
Cards
You should always use micro SDHC or Micro SDXC cards with a class rating of 10 or above. The
cards may either be formatted as FAT32 or exFAT. Cards with a capacity of 200GB have been
tested.
Important: If the firmware detects that the card is too slow (class rating too low), it will decrease the
recording speed and/or resolution.
Formatting
Standard formatting tools provided by the operating system are not always reliable and should not
be used. In addition, they do not optimize the SD card's performance.
For optimal card performance it is recommended to either use the Windows setup program
(mSetup, see below) or use the camera's built-in formatter. Instructions for In-Camera Formatting
are outlined below.
In-Camera formatting is also available via the OSD menu.
Another excellent formatting utility is "SD Formatter" which can be downloaded from
https://www.sdcard.org/downloads/formatter_4/index.html. This utility has been specifically
designed to format SD cards.
In-Camera Formatting
The Camera contains a built-in formatter which should be used to format the SD card.
1. Disconnect the camera and ensure it is turned off.
2. Turn on the camera and wait until it is in one of the Standby modes (steady yellow, blue or
red LED).
3. ► If the camera was set to auto-record, press the Shutter button to stop the recording.
4. Press and hold down the Shutter button. DO NOT RELEASE the button.
5. Very quickly press the Mode button 4 times.
6. ► If the LEDs don't start to blink, release the buttons and start over again at 4.
7. The LEDs will blink very quickly while the card is being formatted.
8. Release the Mode and Shutter buttons once the LEDs start to blink (see above).
Instruction Manual Mobius Min... 1
10/21/2016 1:05:50 PM

Summary of content (9 pages)