Parts List/Tune Up Info

Tune-up procedure

Each device is individually calibrated during manufacturing. Measurement is

performed in a full calibrated setup.

Measurement procedure is outlined below:

1. Set the device to operational voltage and on a predefined band class

and channel.

2. The maximum output power is measured when the power control bit is

set as all UP bits. The RF output power will be adjusted equal or lower

than tested power shown in the test report.

The user has no possibility to change these settings.

Tune up procedure shall be over the power range or at specific operating

power levels.

1. It must provide an operational voltage to turn on the device and

on one certain channel in service mode by means of company

proprietary software.

2. The Base station simulator measures the device specific RF

characteristics.

3. The maximum gains of each individual device are adjusted until

the target value met.

Conducted Power Table

Channel

Mode

Target Power (dBm)

Tolerance (dBm)

462.5625

FRS

8.5

(-0.5,+0.5)

PAGE 1
Tune-up procedure Each device is individually calibrated during manufacturing. Measurement is performed in a full calibrated setup. Measurement procedure is outlined below: 1. Set the device to operational voltage and on a predefined band class and channel. 2. The maximum output power is measured when the power control bit is set as all UP bits. The RF output power will be adjusted equal or lower than tested power shown in the test report. The user has no possibility to change these settings.